Streszczenie treści zawartej na stronie nr. 1
User’s Manual for
Cordless Telephone with
Caller ID/Call Waiting 9125
Part 2
Please read Part 1 — Important Product
Information, included in your package.
Lucent 9125 cover.L1 3 4/8/98, 11:31 AM
Streszczenie treści zawartej na stronie nr. 2
© 1998 Philips Consumer Communications L.P. All rights reserved. Printed in China. 848116232 Issue L1 Lucent 9125 cover.L1 2 4/8/98, 11:30 AM
Streszczenie treści zawartej na stronie nr. 3
CONTENTS Storing a Pause in a INSTALLATION................................. 3 Memory Number ............................. 12 Table/Desk Installation .......................... 3 Dialing Memory Numbers ................... 12 Wall Installation ..................................... 4 Memory Guard .................................... 12 Belt Clip ................................................ 5 Caller ID Operation.......................13 TELEPHONE OPERATION ................. 6 About Caller Identi
Streszczenie treści zawartej na stronie nr. 4
2 Lucent 9125 book.L1 2 4/8/98, 11:24 AM
Streszczenie treści zawartej na stronie nr. 5
INSTALLATION Standard Modular Electrical Telephone Outlet Jack Telephone Line Jack Telephone Line Cord Power Cord Table/Desk Installation 1 Choose a spot near an electrical outlet and a telephone jack. This phone requires a modular telephone jack and a standard electrical outlet (110v AC). The outlet should not be controlled by a wall switch. 2 Install the handset battery. (For an illustration of battery installation, see BATTERIES in this manual.) • Remove the battery cover by pressing on the
Streszczenie treści zawartej na stronie nr. 6
INSTALLATION 4 Connect the telephone line cord. Plug one end of the telephone line cord into the jack on the back of the base. Plug the other end of the line cord into a modular jack. Make sure the plugs snap firmly in place. 5 Connect the power cord. Plug the power adapter into the jack labeled 11V DC on the back of the base. Plug the AC adapter on the power cord into an electrical outlet not controlled by a wall switch. The POWER light on the base goes on. 6 Charge the handset batteries for
Streszczenie treści zawartej na stronie nr. 7
INSTALLATION 3 Connect the power cord. • Plug the power adapter into the jack labeled 11V DC on the back of the base. • Run the cord under the tab on the bottom of the base unit and under the tab on the wall mounting base. • Plug the AC adapter into an electrical outlet not controlled by a wall switch. 4 Connect the telephone line cord. • Using the short telephone line cord supplied, insert one end of the telephone line cord into the telephone jack on the back of the base. • Feed the excess line
Streszczenie treści zawartej na stronie nr. 8
TELEPHONE OPERATION Latch for Spare Battery Compartment Light goes on when system is connected to power and phone line Send paging tone to handset Light goes on when spare battery (optional) is placed in Spare Battery Compartment Light goes on when handset is in use, or when handset is charging in base Directory card 6 Lucent 9125 book.L1 6 4/8/98, 11:25 AM
Streszczenie treści zawartej na stronie nr. 9
TELEPHONE OPERATION Handset Volume Control Headset jack Make or answer a call / Access custom calling services End a call Put caller on hold / Store a pause in a memory number View the telephone number of Call View long History number on the display Caller ID names Scroll through Temporary Tone / Call History Scroll through Call History Access Call History for Caller ID service Access numbers in telephone memory Redial last number called Store numbers in telephone memory Allows you to hear calle
Streszczenie treści zawartej na stronie nr. 10
TELEPHONE OPERATION Making a Call 1 Press and release P, and wait for a dial tone. The screen displays PHONE ON. 2 When you hear a dial tone, dial the number. — OR — 1 Enter the number you want to call. 2 Press and release P. The screen displays PHONE ON and the call is dialed. Answering a Call Press any key except O, M, or a volume key. Ending a Call Press O on the handset — OR — Place the handset in the cradle. Redial The last number dialed on this phone (up to 16 digits) is stored in redial
Streszczenie treści zawartej na stronie nr. 11
TELEPHONE OPERATION Handset Ringer Selection You can select from four different handset ringer styles. You can also turn off the ringer. 1 Make sure the handset is off. 2 Press G, #. 3 Press 1, 2, 3 or 4 to select your ringer style. You will hear a sample of the ringer style and the screen will display your selection. 4 Press O. Turning Ringer Off 1 Press G, #. 2 Press 0. 3 Press O. The screen displays RINGER OFF SELECTED. Checking Handset Ringer Selection 1 Press G, #. 2 Press #. You will h
Streszczenie treści zawartej na stronie nr. 12
TELEPHONE OPERATION Special Telephone Services If you subscribe to special local telephone company services like Call Waiting or Call Forwarding, you can access them by pressing P whenever you would press the switchhook on a corded phone. This is like the Flash feature on some other phones. Page/Handset Locator The Page feature allows you to signal someone at the handset from the base. You can also use this feature to help you locate the handset. Press L on the base. The handset will ring four
Streszczenie treści zawartej na stronie nr. 13
OPERATING RANGE This cordless telephone operates at the maximum power allowed by the Federal Communications Commission (FCC). Even so, this handset and base can communicate over only a certain distance — which can vary with the locations of the base and handset, the weather, and the construction of your home or office. For best performance, keep the base antenna fully extended. If you receive a call while you are out of range, the handset might not ring — or if it does ring, the call might not
Streszczenie treści zawartej na stronie nr. 14
TELEPHONE MEMORY This cordless phone can store 20 telephone numbers that you can dial just by pressing m and two number buttons. Storing Memory Numbers 1 Make sure the handset is off. 2 Enter the number you want to store (up to 20 digits) — OR — Press R to store the last number dialed. 3 Press G. The screen displays PROGRAM LOCATION__. 4 Enter a location key (01–20) to select a memory location. The handset sounds a confirmation tone. NOTE: If there’s a problem storing numbers, the screen disp
Streszczenie treści zawartej na stronie nr. 15
CALLER ID OPERATION About Caller Identification This telephone is designed to store and display information about incoming calls. It must be used with Caller Identification service provided by your local telephone company; there is a fee for this service, and it may not be available in all areas. This phone can provide information only if both you and the caller are in areas offering Caller Identification service, and if both telephone companies use compatible equipment. When you use this phon
Streszczenie treści zawartej na stronie nr. 16
CALLER ID OPERATION Reviewing Call History 1 Press and release C. The screen displays CALL #01 and the name of the most recent caller. 2 Press 7 to display the phone number and time of the displayed call. 3 If call information is followed by →, press 9 to see the information that did not fit on the screen. 4 Press > or < to scroll forward or backward through the call history. Removing a Call from Call History Press and release c to remove displayed information from the call history. The screen
Streszczenie treści zawartej na stronie nr. 17
BATTERIES CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and follow these instructions carefully. • Use only Replacement Battery 3470. • Do not dispose of the battery in a fire. The cell might explode. Check with local codes for special disposal instructions. • Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed. • Exercise care in handling batteries in order n
Streszczenie treści zawartej na stronie nr. 18
BATTERIES Charging the Spare Battery Pack The Spare Battery Charging Compartment is located in the base cradle. You can use the spare battery pack to replace the current handset battery pack right away if it becomes depleted. The spare handset battery pack is optional, and must be purchased separately. 1 Open the battery door on top of the base cradle by lifting the latch on top. 2 Insert the battery. The SPARE BATT CHARGING light goes on. 3 Replace the battery door. The spare battery will b
Streszczenie treści zawartej na stronie nr. 19
IN CASE OF DIFFICULTY If you have difficulty operating this phone, try the suggestions below. If you still have trouble, call 1 800 PCC–9125. If the phone doesn’t work at all, check these items first: • Make sure the AC adapter is plugged into an outlet not controlled by a wall switch. • Make sure the telephone line cord is plugged firmly into the base unit and the modular jack. • Make sure the base antenna is fully upright. • If the screen displays LOW BATTERY, the battery pack needs rechargin
Streszczenie treści zawartej na stronie nr. 20
IN CASE OF DIFFICULTY If the phone does not ring when you receive a call: • Make sure the handset ringer is on. • Make sure the telephone line cord is connected firmly to the base and the telephone jack. • Make sure the AC adapter is plugged firmly into an outlet not controlled by a wall switch. • You might be too far from the base; move closer. • You might have too many extension phones on your telephone line to allow all of them to ring. Try unplugging some of them. If you hear other calls w
