Streszczenie treści zawartej na stronie nr. 1
Table of Contents
Safety Instructions........................................................................................4
General Safety Instructions......................................................................4
Product Safety Instructions ......................................................................4
Battery Safety Instructions .......................................................................6
Regulatory Information ..........
Streszczenie treści zawartej na stronie nr. 2
Advanced Operations.................................................................................31 Safety Instructions Handset Registration..............................................................................31 Handset Group Subscription..................................................................32 Caution: Your wireless telephone gives you freedom and flexibility to stay Registration of Additional Base..............................................................32 in t
Streszczenie treści zawartej na stronie nr. 3
3. Changes or modifications to this product not expressively approved by 14. Do not place the product where persons can step, trip, or fall on it. the manufacturer will void the warranty and the FCC authorization to 15. Do not place conductive objects over or near the antenna. operate the equipment. Use only manufacturer provided accessories. 16. Do not use the product to report a gas leak while in the vicinity of the 4. Do not use the telephone near water. Never spill liquid of any kind
Streszczenie treści zawartej na stronie nr. 4
Regulatory Information Notes: In the event of any inconsistency between the English DuraFon 1X and French versions hereof, the English version shall FCC ID: NI3-SN1302 prevail. IC: 3616A-SN1302 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. 1. The term “IC:”
Streszczenie treści zawartej na stronie nr. 5
Equipment Checklist Handset Illustration 1. In a Base + Handset package, please find the following components: a. Base Station x 1 b. Base Antenna x 1 c. Base AC/DC Adaptor x 1 d. Handset x 1 e. Low Profile Handset Antenna x 1 f. Optimal Performance Handset Antenna x 1 g. 1700mA Li-i
Streszczenie treści zawartej na stronie nr. 6
b. Sends a Flash signal to phone line to retrieve a dial tone after the Handset Features call ends, or to perform the call waiting feature provided by local phone companies during a call. Basic Handset Features c. Press and hold the key for one second to enable/disable 1. 4-line LCD (Liquid Crystal Display) speakerphone. a. The LCD display has LED (Light Emitting Diode) for backlighting. st line of LCD consists of icons. 4. 2-WAY/INTERCOM b
Streszczenie treści zawartej na stronie nr. 7
2. Ringer Vibrator a. Five-level ringer volume selections (high/ low/ vibrate/ vibrate-then- 9. Any Key Answer (except END, Silent Soft Key) ring/ off) b. Four ringer type selections 10. Key-guard 3. Caller ID 11. Dialing Prefix a. Displays incoming call phone number and name on the LCD (needs a. Up to 14 digits, including pause(s), one access code can be pre- Caller ID service from local telephone company) programmed to be added automatically in front of the dial
Streszczenie treści zawartej na stronie nr. 8
a. Allow user to pre-program the most frequently used PBX feature Base Illustration along with its feature code into DuraFon which is adjunct to the PBX system b. Up to 9 entries can be saved c. Once the feature and feature codes being programmed, you can quick perform those functions during the call by pressing OPTION soft key. Administrator Features Ha
Streszczenie treści zawartej na stronie nr. 9
Base Features Charger Illustration Basic Base Station Features 1. Antenna a. The antenna port has a reverse thread connector; to remove antenna or cable, turn clockwise; to install, turn counterclockwise. Improper installation may damage the connector b. When using an outdoor antenna, locate the antenna (not the base station itself) as high as possible for a clear transmission path. 2. LED a
Streszczenie treści zawartej na stronie nr. 10
Charger Features Getting Started Base Station Installation 1. DC In There are three possible base station setups: Connects to Charger AC Adaptor. Base station alone 2. Handset Charging Slot Base station plus telephone answering device Base station plus standard telephone a. Charge handset battery when handset is placed in cradle. b. Refer to the handset LCD for charging status For best performance, maintain at least a distance of 1 meter (about 3 feet) (1) Charging: LCD sc
Streszczenie treści zawartej na stronie nr. 11
and receiving phone calls and intercom calls. No base station or handset Basic Operations programming is needed for basic operations. Operation Modes Both the base station and handset have levels of operation at which time Note: only certain procedures of functions can be performed. 1. Handset(s) packaged along with a Base Station are pre- registered at the factory. If you have a new handset, you will need to register the handset with the base station in order to be A. Base Opera
Streszczenie treści zawartej na stronie nr. 12
Streszczenie treści zawartej na stronie nr. 13
handset responds. “BROADCAST” key 11 b. Hear bi-bi-beep while the initiating handset PA paging 4. Before a handset answers, the INTERCOM can be cancelled from the broadcast all handsets within communication to Ext. # 12 base by pressing INTERCOM again. However, once a handset answers, coverage only the answering handset can end the call. c. Start to speak the message to be broadcasted once you hear the “beep” sound; the C. Intercom/2-Way from Handset to Ba
Streszczenie treści zawartej na stronie nr. 14
[Note] Intercom numbers (Handset ID) are not stored in the last 10 To end a telephone or intercom call, press END key or place handset into numbers dialed log. charger cradle. Receiving a Telephone Call Adjusting Receiver (Earpiece) Voice Volume 11 00:00:10 1. When an incoming call arrives, the ringer will ring or vibrate unless the 1. Voice volume can only be adjusted during a call. Volume:4 ringer has been turned off. OPTION HOLD 2. There are 6
Streszczenie treści zawartej na stronie nr. 15
effective only for the current call. hold. Do Not Disturb (Silent Ring) 3. Battery talk time and standby time vary depending on the talk/standby pattern and the operating distance. Putting the handset back to charger 11 1. Enter the key sequence MENU – Sounds – Ring cradle as often as possible is recommended for best performance. Use Sounds: Volume, then select “Off”. Press SAVE to confirm 1. Ring Volume only manufacturer provided battery and charg
Streszczenie treści zawartej na stronie nr. 16
pressing the REG button. The handset has a 12 second Advanced Operations registration timeout starting from the registration or de- registration option has been selected. The base and handset Handset Registration will automatically exit registration mode after timeout. 2. When you conduct the registration procedure with BASE 20, the 1. If your handset(s) is purchased as part of a system, it has been pre- handset ID will be ranging from 21 to 29. registered with the base stat
Streszczenie treści zawartej na stronie nr. 17
rd th 3 , and 4 base unit. (1) Speak to the destination handset. (2) Press XFER soft key or the END to end announcement. The call is transferred to the destination handset. 3. Registration: a. Press MENU-6 from HS 11 to enter the 11 Notes: If the destination handset does not answer after handset registration mode Main Menu: paging timeout, the call is routed back to the originating handset. b. Press and hold the Registration (REG)
Streszczenie treści zawartej na stronie nr. 18
a. Press Menu-9 and enter the two-digit base ID to designed handset ID to a specific handset. Press 11 11 Main Menu: enter the System mode. Menu-9 and enter the two-digit base ID to enter Please enter 8. Call Manager b. Press 1 to enter Tone selection the administration mode. Ext. #:** 9. System c. You can adjust the dial mode between Tone and b. Press 4 and then enter two digits ID number to be CANCEL Pulse. The
Streszczenie treści zawartej na stronie nr. 19
search method to locate the record to be erased Notes: or edited. 1. When enter a phone number, the cursor automatically advances to the next digit field. Use or scrolling key to move the cursor backward or forward b. Press OPTION soft key to enter editing menu. 11 to insert or
Streszczenie treści zawartej na stronie nr. 20
confirm your selection. the character. For example, you are editing the 11 Meeting now message 1 as “Meeting now.” 3. To edit the Call barring code (3) When finished, press SAVE soft key to save 11 SAVE12 ODELETE a. Once turn on the call barring feature, you can key change. You will see the Text Message ID as 01 Call Barring in the “call barring” code. on the upper right corner of the LCD screen. On 11 01 SAVE SET PW
