Streszczenie treści zawartej na stronie nr. 1
E
N
G
L
I
C4205 User Guide
S
H
2.4 GHz Cordless Telephone
™
Featuring Digital Clarity Power Technology
E
S
P
A
~
N
O
L
F
R
A
N
Ç
A
I
S
Streszczenie treści zawartej na stronie nr. 2
Streszczenie treści zawartej na stronie nr. 3
TABLE OF CONTENTS Important Safety Instructions ..............................4 Features ..........................................................8 Choosing a Location .......................................10 Telephone Installation ......................................12 Handset Battery .............................................13 Telephone Handset Features ............................15 Telephone Base Features .................................17 Using Your Telephone ......................
Streszczenie treści zawartej na stronie nr. 4
IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the telephone. 3. Do not use this telephone near a bath tub, wash basin, kitchen sink or laundry tub, in a wet basement, near a swimming pool or any where else there is water. 4. Avoid us
Streszczenie treści zawartej na stronie nr. 5
IMPORTANT SAFETY INSTRUCTIONS 10. Do not place anything on the power cord. Install the telephone where no one will step or trip on the cord. 11. Do not overload wall outlets or extension cords as this can increase the risk of fire or electrical shock. 12. Never push any objects through the slots in the telephone. They can touch dangerous voltage points or short out parts that could result in a risk of fire or electrical shock. Never spill liquid of any kind on the telep
Streszczenie treści zawartej na stronie nr. 6
IMPORTANT SAFETY INSTRUCTIONS F. If the telephone exhibits a distinct change in performance. 15. Never install telephone wiring during a lightning storm. 16. Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. 17. Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. 18. Use caution when installing or modifying telephone lines. 19. Use only t
Streszczenie treści zawartej na stronie nr. 7
IMPORTANT SAFETY INSTRUCTIONS For Handset Unit: 3.6V 600mAHr NiMH Rechargeable Battery Sanik Battery Co. Ltd.: 3SNAAA60HSJ1 GPI International Ltd.: GP60AAAH3BMJZ For Base Unit: Four (4) AA alkaline batteries 2. Do not dispose of the battery in a fire as it may explode. Check with local codes for possible special disposal instructions. 3. Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes and skin. It may be tox
Streszczenie treści zawartej na stronie nr. 8
FEATURES Telephone Base 1. Handset Page 2. Ringer Volume 3. Ringer Style 4. Ringer On/Off 5. Antenna/Visual Ringer 5 1 4 3 2 8
Streszczenie treści zawartej na stronie nr. 9
FEATURES Handset 1. Neckloop Jack 9. Flash 2. Handset Volume 10. Mute 3. Boost 11. Redial/Pause 4. Dial Pad 12. Handset Ringer Off/Vibe/On 5. Emergency Buttons 13. Handset Tone 6. Talk 14. Belt Clip 7. Channel 15. Headset Jack 8. Memory 16. Antenna/Visual Ringer 15 1 16 5 2 7 13 6 8 3 12 4 14 9 11 10 9
Streszczenie treści zawartej na stronie nr. 10
CHOOSING A LOCATION 1. This phone requires a modular phone jack (RJ11C) and a standard 120V AC wall outlet. 2. Plug the AC Adapter directly into outlet. 3. Do not plug other appliances into the same outlet or have outlet controlled by a 9V DC wall switch. TE L 400 mA 4. Choose a location that is out of the way of USE ONLY WITH CLASS (CLASSE) 2 POWER SOURCE normal activities. CAUTION: USE ONLY WITH CLASS 2 POWER SOURCE 9V DC, 400MA. Always connect the AC Adapter to the
Streszczenie treści zawartej na stronie nr. 11
TABLE/DESK TOP INSTALLATION CAUTION: Disconnect the telephone line cord before connecting or disconnecting the battery backup in the wall mount bracket. 1. Plug one end of the supplied modular tele- phone line cord into the jack marked TEL located on the back of the telephone base as shown in the diagram. 2. Plug the modular telephone line cord’s other end into a modular phone jack. 3. Insert the supplied AC Adapter’s plug into the jack marked 9V DC 400mA located on the ba
Streszczenie treści zawartej na stronie nr. 12
WALL MOUNTING INSTALLATION CAUTION: Disconnect the telephone line cord before connecting or disconnecting the battery backup in the wall mount bracket. The base unit may be mounted on a standard wall plate. 1. Plug one end of the supplied short modular telephone line cord into the TEL jack located on the back of the base of the phone. 2. Insert the plug of the AC adapter into the jack marked DC 9V 400mA located on the back of the telephone base. 3. Align the mounting bracket on th
Streszczenie treści zawartej na stronie nr. 13
8. Set the Tone/Pulse switch located on the end of the base to correct dialing mode. Please check with your local Phone Com- pany if uncertain of the type of service. 9. Place handset in the cradle to begin initial charging. Remember, you must charge the phone for at least 12 hours before you use the phone for the first time. Note: Remember, you must charge the phone for at least 12 hours before you use the phone for the first time. HANDSET BATTERY INSTALLATION Battery T
Streszczenie treści zawartej na stronie nr. 14
Low Battery When the handset battery gets low, there will be two (2) beeps every thirty (30) seconds. If the battery becomes low while you are on a call, you will be disconnected after about two (2) minutes. Terminate the call and recharge the battery. To recharge the battery pack, place the handset in the base. 1. Make sure the contact points are touching and the CHARGE LED is lit. 2. Be careful not to short battery with Conducting materials such as rings, bracelets and keys. T
Streszczenie treści zawartej na stronie nr. 15
TELEPHONE HANDSET Digital Clarity Power Technology With Digital Clarity Power, the high frequency sounds are amplified more than the low fre- quency sounds so words are not just louder, but clearer and easier to understand. It also provides intelligent amplification to make soft sounds audible, while keeping loud sounds bearable. BOOST – Clarity Power On/Off Boost On: Talk button is ORANGE The C4205 has a button that controls the loud- ness of the receiver. Once the BOOST button is Boost
Streszczenie treści zawartej na stronie nr. 16
Handset Ringer Set the switch marked Ringer OFF/VIBE/ON located on the side of the handset. When VIBE is selected the handset will ring and vibrate when receiving an incoming call. The ringer switch must be set to ON or VIBE for the handset to ring. NOTE: If both handset and base ringers are set to OFF, the visual ringer will flash to indicate there is an incoming call. Headset Jack You can use this telephone hands-free when you install a 2.5mm headset (purchased separately). To install,
Streszczenie treści zawartej na stronie nr. 17
TELEPHONE BASE Ringer Volume The base ringer volume adjustments are located on the side of the telephone base. Pressing the UP ( ) key on the base increases the ringer sound by one level while pressing the DOWN ( ) key reduces the sound by one level. There are a total of six levels from maximum to minimum. The ringer will sound for two (2) seconds while choosing a ringer volume, to allow the user to make a choice. Ringer Style The base ringer style adjustments are located on the side
Streszczenie treści zawartej na stronie nr. 18
BOOST ON/OFF Switch This switch will disable the reset feature of the BOOST Clarity Power button as follows: ON – When the BOOST ON/OFF switch is set to ON, the Boost function will be ON every time a call starts, and will default to ON every time the phone hangs up. During a call, the BOOST Clarity Power button can toggle the Clarity Power ON or OFF according to the user’s needs. OFF – When the BOOST ON/OFF switch is set to OFF, the Boost function will be OFF every time a call starts, a
Streszczenie treści zawartej na stronie nr. 19
Mute The MUTE button allows the user to conduct a private conversation that you do not want the person on the other end to hear. While in the mute mode, the MUTE button will illuminate RED and the microphone in the handset is disabled. Pressing the MUTE button again will disengage the MUTE feature. Redial/Pause Press the RD/P button to redial the last number dialed. Pressing the RD/P button while storing a telephone number will insert a four (4) second pause. This is commonly used
Streszczenie treści zawartej na stronie nr. 20
5. Install desk/wall mount bracket to telephone base. To Replace Battery Backup Batteries 1. Disconnect telephone line cord and remove desk/wall mount bracket from telephone base. 2. Disconnect battery back-up connector from the telephone base. 3. Remove batteries from desk/wall mount bracket. 4. Install four (4) AA Alkaline batteries with negative (-) end of battery touching the spring. 5. Connect battery back-up connector to terminal on bottom of telephone base 6. Ins