Whirlpool WRS555SIHZ user manual

The knob at the bottom of a Whirlpool WRS555SIHZ refrigerator is a leveler. It is used to adjust the height of the front and back of your refrigerator to make sure it is level.

No, the Whirlpool WRX735SDHZ does not have a specific reset button. However, if you are experiencing issues with your refrigerator, you can try a few troubleshooting steps to potentially resolve the problem. These steps may include checking the power supply, ensuring the temperature settings are correct, cleaning the condenser coils, and checking for any blocked vents. If these steps do not resolve the issue, it is recommended to consult the user manual or contact Whirlpool support for further assistance.

To clean the ice and water dispenser on a Whirlpool refrigerator, follow these steps:
1. Unplug the refrigerator: For safety purposes, disconnect the refrigerator from the power source.
2. Remove any ice or water: Empty the ice bin and remove any remaining ice cubes. Pour out any water from the water dispenser.
3. Remove the drip tray: If your model has a removable drip tray located at the bottom of the dispenser, take it out.
4. Clean the exterior: Use a mild dish soap and warm water to wipe down the entire exterior of the dispenser. Pay attention to any areas that are visibly dirty or sticky. Dry the surface with a clean cloth.
5. Clean and sanitize the drip tray: If your refrigerator has a removable drip tray, wash it with warm water and mild dish soap. Rinse it thoroughly and dry it completely before placing it back.
6. Clean the dispenser nozzle or spout: Use a small brush or an old toothbrush soaked in vinegar to scrub the nozzle or spout of the water dispenser. This will help remove any mineral deposits or buildup. Rinse it with clean water afterward.
7. Flush the water system: Fill a cup with vinegar and place it under the water dispenser. Run water through the system for a few minutes to flush out any impurities or residual cleaner. Dispose of the vinegar-filled cup and refill it with clean water. Run water through the system again to remove any leftover vinegar.
8. Clean the ice dispenser: If the ice dispenser is removable, take it out and clean it with warm water and dish soap. Rinse it thoroughly and let it dry completely before installing it back.
9. Plug the refrigerator back in: Once you have finished cleaning all the components of the dispenser, plug the refrigerator back into the power source.
Remember to consult the owner's manual specific to your model for any additional instructions or precautions.