Waterpik WP-560 user manual

There could be several reasons why your cordless Waterpik is not spraying water. Here are a few common issues and troubleshooting steps:
1. Check the water reservoir: Ensure that the water reservoir is securely attached and filled with water. If it is not properly connected, the water may not reach the unit.
2. Check the battery: Make sure the battery is fully charged. If the battery is low or dead, the unit may not function properly. Recharge the battery according to the manufacturer's instructions.
3. Check the water pressure setting: Ensure that the water pressure is set to an appropriate level. If the pressure is too low, it may not result in adequate water flow. Adjust the pressure control to the desired level.
4. Clean the nozzle: Mineral build-up or debris in the water nozzle can obstruct water flow. Remove the nozzle and clean it thoroughly with warm water and a soft brush. Make sure to remove any clogs or blockages.
5. Check for any leaks: Inspect the unit for any leaks or cracks that may be affecting the water flow. If you find any issues, contact the manufacturer for assistance.
If none of these troubleshooting steps resolve the issue, it is recommended to reach out to the Waterpik customer support for further assistance or consider getting the unit serviced or replaced if necessary.

Using a Waterpik can be done before or after flossing based on personal preferences. However, some dental professionals suggest that you should use the Waterpik after flossing so any loose particles that the flossing may have missed can be flushed away. It's best to follow the advice of your own dentist or dental hygienist.

The Waterpik WP-560 Water Flosser has a built-in indicator light that shows the charging status. When you first plug in the device, the light will illuminate red, indicating that it is charging. Once the flosser is fully charged, the light will turn green. Typically, it takes about four hours to fully charge the Waterpik WP-560.

The Waterpik WP-560 is a portable cordless water flosser that offers three pressure settings: low, medium, and high. The specific pressure setting you should use may vary depending on your personal preference, oral health needs, and any recommendations from your dentist or dental hygienist.
Generally, it is recommended to start at the lowest pressure setting and gradually increase it until you find a comfortable and effective level for your gums and teeth.
If you are new to water flossing or have sensitive gums, the low or medium pressure setting may be more suitable. On the other hand, if you have healthy gums and want a more thorough cleaning, you can choose the medium or high pressure setting.
It is important to note that excessive pressure can potentially irritate or damage the gums, so it's best to avoid using the highest setting if you have any gum sensitivity or gum disease without consulting your dental professional first.
In any case, it is always advisable to consult with your dentist or dental hygienist for personalized advice on the most appropriate pressure setting for your specific oral health needs.