Turtle Beach STEALTH-600-GEN-2 user manual

The Turtle Beach Stealth 600 Gen 2 headset features four audio presets that you can switch between:
1. Signature Sound: This default mode is meant for general usage and aims to provide the best sound for a variety of content types.
2. Bass Boost: This mode increases the bass to produce a deeper, richer low-end sound.
3. Bass + Treble Boost: This preset balances an increase in both bass and treble sounds, creating a dynamic range that enhances every high and low in your audio.
4. Vocal Boost: Geared towards dialogue and vocal content, this preset aims to enhance the clarity and audibility of speech and vocals.
These modes can help tailor your listening experience to the content you're consuming. You can switch between them using the "Mode" button on your headset.

To set up the Turtle Beach Stealth 600 Gen 2 headset, you will need to follow these steps:
1. Begin by charging the headset using the included USB cable. Connect the cable to a USB port on your computer or a USB wall charger. The headset should be fully charged before proceeding to the next step.
2. Turn on your gaming console or PC and navigate to the audio settings.
3. For Xbox consoles:
- Press the Xbox button on your controller to open the guide.
- Go to Profile & System > Settings > Devices & Connections > Accessories.
- Under "Devices," select the controller you want to update.
- Follow the on-screen instructions to update the controller firmware.
4. For PlayStation consoles:
- Go to Settings > Devices > Bluetooth Devices.
- Make sure Bluetooth is enabled on the console.
- Press and hold the power button on the headset until the LED indicator begins to flash rapidly in a blue color.
- On the console, select "Wireless Controller" from the available devices.
5. For PC:
- Connect the USB wireless transmitter to an available USB port on your computer.
- Allow the computer to install any necessary drivers.
- The headset should automatically connect to the transmitter.
6. Once the headset is connected, adjust the audio settings on your console or PC to use the Turtle Beach Stealth 600 Gen 2 as the primary audio output device. You may also need to adjust the microphone settings to use the headset's microphone.
7. Finally, you can customize the headset's settings using the Turtle Beach Audio Hub software. Download and install the software from the official Turtle Beach website. The software allows you to update the headset's firmware, adjust the audio settings, and create custom sound profiles.
Now you should be all set up and ready to use your Turtle Beach Stealth 600 Gen 2 headset!

The mode button on the Turtle Beach Stealth 600 Gen 2 allows you to cycle through different audio presets or EQ (equalizer) settings. It lets you customize the sound profile according to your preferences. The available audio presets may include options like signature sound, bass boost, treble boost, or vocal focus, among others.

To reset your Turtle Beach Stealth 600 Gen 2 headset, you can follow these steps:
1. Turn off your headset by pressing the power button.
. Press and hold the Pairing button located on the bottom of the left earcup until you hear a tone.
3. Keep holding the Pairing button and wait for the LED on the headset to start flashing rapidly.
4. Once the LED starts flashing rapidly, release the Pairing button.
5. Your headset is now reset and ready to be re-paired with your device. Pair it again following the usual pairing process.
Note: Resetting your headset will erase any saved settings, so you may need to set up the audio and mic settings again after the reset.