Speed Queen AWN63RSN115TW01 user manual

1. Before starting, ensure you have the right detergent. Speed Queen recommends using a high efficiency or 'HE' detergent.
2. Remove the washer lid by lifting it upwards.
3. You will see a central agitator in the washing machine. Around it, there should be a dispensing cup or a portion in the drum where you can put the detergent.
4. Measure the recommended amount of detergent. Many detergents have a measuring cup included in the packaging. Refer to the detergent bottle for the correct amount.
5. Pour the detergent directly into the drum or dispensing cup of the washer. Avoid adding detergent on top of clothes as it can stain them.
6. If you are using fabric softener, bleach, or pre-wash stain remover, make sure to place them in their respective dispensers or add them at the appropriate time according to your model’s directions.
7. Once everything is added, you can load your laundry into the washer. After loading, you can close the lid and then select your desired settings on the washing machine panel. Press 'start' to begin the washing cycle.
Note: Instructions may vary slightly between different models of Speed Queen washers; always refer to your user manual for specific instructions.

The debris filter in a Speed Queen washer is typically located at the bottom front of the machine. To access it, you will need to slightly lift the front cover panel or remove any screws holding it in place. Once the cover is removed, you should see a round or rectangular cover with a small handle or notch. This is the debris filter. You can open it by turning the handle counterclockwise or pulling the notch, depending on the model. Make sure to have a towel or basin to catch any water that might spill when removing the filter.

There can be several reasons why your Speed Queen washer is not working. Here are some common issues to check for:
1. Power Supply: Ensure that the washer is receiving power by checking if it is plugged in properly and the circuit breaker is not tripped.
2. Water Supply: Check if the water supply valves are fully turned on and the water hoses are not kinked or clogged.
3. Door/Lid Switch: The washer may not start if the door or lid switch is malfunctioning. Make sure the door or lid is closed securely so that the switch is engaged.
4. Timer or Control Board: If the washer is not starting or does not proceed through its cycle, there could be an issue with the timer or control board. In such cases, it is recommended to contact a technician for professional diagnosis and repair.
5. Drainage Issues: If the washer is not draining water, check for clogs in the drain hose or the pump filter. Ensure that the drain hose is installed correctly and not positioned too low, as this can cause water to flow back into the drum.
If none of these troubleshooting steps resolve the issue, it is advised to contact Speed Queen customer service or a qualified technician for further assistance.