Skullcandy INDY user manual

1. Check the Audio Balance: Look in the settings of your device to see if the audio balance is centered. Sometimes, the balance might be shifted entirely to the right or left, causing only one of the earbuds to produce sound.
2. Clean the Earbuds: Gunk build-up in the earbuds can block the sound. Use a soft cloth or a small brush to clean the mesh of the earbuds carefully.
3. Check the Jack: Bent, broken or dirty jacks can also be plausible reasons for why you might be getting sound in only one earbud. You may clean it with a slightly damp toothbrush but only as a last resort.
4. Swap Earbuds: If your earbuds are modular and allow swapping between left and right, try swapping them. If the issue persists, the trouble is in the earbuds. If not, the wire might be the culprit.
5. Check the Wire: Sometimes the wire might be the root of your problems. Observe the wire for signs of wear and tear. Wiggling the wire around while the music is playing could spot a loose connection.
6. Repair or Replace: If you've exhausted all other steps, it's time to either get them professionally repaired or to replace the pair altogether.
Remember, tampering with your earbuds in a way that's not recommended by the manufacturer could void the warranty. If your earbuds are still in warranty, make sure you take them to a service center.

There could be a few reasons why your Skullcandy Indy earbuds are not pairing together. Here are some troubleshooting steps you can try:
1. Make sure both earbuds are fully charged. Low battery levels may prevent them from pairing.
. Reset both earbuds by placing them in the charging case and removing them after 10 seconds. This can help resolve any connectivity issues.
3. Forget the Bluetooth pairing on your device and then try to reconnect the earbuds. On your device, go to Settings > Bluetooth > Skullcandy Indy and select "Forget" or "Unpair." Then follow the pairing instructions to connect them again.
4. Ensure that your earbuds are not already connected to another device. If they are, disconnect them and try pairing them with your desired device again.
5. Update the firmware of your Skullcandy Indy earbuds. Visit the official Skullcandy website and look for any available firmware updates for your specific model.
6. If none of the above steps work, try contacting Skullcandy customer support for further assistance. They may be able to provide specific troubleshooting steps or suggest a repair or replacement if necessary.
Remember, the exact steps may vary depending on the specific model of your Skullcandy earbuds, so refer to the user manual or Skullcandy's official website for detailed instructions.

To put your Skullcandy Indy earbuds in pairing mode, you can follow these steps:
1. Make sure the earbuds are turned off and not currently connected to any device.
2. Press and hold the button on both earbuds simultaneously for at least 6 seconds. You will see the LED lights on the earbuds start flashing rapidly, indicating they are in pairing mode.
3. Open the Bluetooth settings menu on your device (phone, tablet, or computer) and turn on Bluetooth if it's not already enabled.
4. In the available devices list, locate and select "Skullcandy Indy" to connect to the earbuds.
5. Once connected, the LED lights on the earbuds will stop flashing and remain solid, indicating the pairing is successful.
Now you should be able to use your Skullcandy Indy earbuds with the connected device.