Shark ROCKET-HV302 user manual

To determine the model of your Shark Rocket vacuum cleaner, you can refer to the following steps:
1. Look for the model number on the main body of the vacuum cleaner. It is usually located on a sticker or label.
2. Inspect the product documentation that came with your Shark Rocket vacuum. The model number should be mentioned in the user manual or on the packaging.
3. Check the Shark website or contact their customer support. You can provide them with the serial number and other identification details, and they should be able to inform you about the specific model you have.
If you are still unable to identify the exact model of your Shark Rocket vacuum, you can consider taking a photo of the vacuum and reaching out to Shark's customer support, as they will be able to assist you further.

There could be several reasons why your Shark Rocket HV302 brush is not spinning. Here are some potential solutions:
1. Check for blockages: Make sure there are no blockages or obstructions that might be preventing the brush from spinning. Turn off and unplug the vacuum, then remove the brush roll and clear away any hair, lint, or debris.
2. Reset the brush roll: Your Shark Rocket HV302 might have a brush roll reset button. Press it to reset the brush roll motor and see if that resolves the issue.
3. Inspect the belt: The brush roll could be powered by a belt that may have come loose, stretched, or become worn out. Check if the belt is intact, properly aligned, or in need of replacement. You may need to refer to your vacuum's user manual for instructions on how to access and replace the belt.
4. Motor issues: If the brush roll still isn't spinning, there might be an issue with the motor itself. In this case, it is advisable to contact Shark's customer support or bring the vacuum to an authorized service center for further inspection and repairs.
Always ensure the vacuum is disconnected from the power source before performing any maintenance or troubleshooting tasks.

The meaning of blinking lights on a Shark vacuum can vary depending on the specific model. Generally, blinking lights indicate a problem or error with the vacuum. To determine the exact meaning of 2 blinking lights on your specific model, it is recommended to consult the user manual or contact the manufacturer's customer support for assistance.

There could be several reasons why your Shark Rocket HV302 vacuum may be experiencing a loss of suction. Some possible causes and solutions include:
1. Full dust cup: If the dust cup is full or clogged, it can restrict airflow and lead to a loss of suction. Empty the dust cup and clean any debris or blockages.
2. Dirty filters: The vacuum may have dirty filters that need to be cleaned or replaced. Check the filters and clean or replace them as necessary.
3. Brushroll blockage: The brushroll may have accumulated hair, threads, or other debris, causing a blockage. Remove the brushroll and clean it thoroughly, removing any obstructions.
4. Clogged hose or wand: Check the hose and wand for any clogs or blockages. Clear any debris that may be obstructing the airflow through the hose and wand.
5. Hose or seal damage: Inspect all hoses and seals for any damage or leaks that could affect suction. Replace any damaged parts if necessary.
6. Power issue: Make sure the vacuum is receiving proper power supply. Check the power cord and ensure it is securely connected and not damaged.
If none of these solutions resolve the issue, it may be best to contact Shark customer support for further assistance or consider taking the vacuum to a professional for repair.