Shark LIFT-AWAY-NV601UKT user manual

Yes, the Shark Lift-Away NV601UKT vacuum has a reset feature. The reset button is usually located on the side or bottom of the vacuum's main body. To reset the vacuum, make sure it's turned off and unplugged from the power source, then locate the reset button and press it for a few seconds. This should reset the vacuum's motor and any internal circuitry.

There could be several reasons why there is no suction on your Shark Lift-Away NV601UKT vacuum cleaner. Here are a few possible causes and troubleshooting steps you can try:
1. Blockage: Check for any obstructions in the hose, brush roll, or wand. Clear away any debris or clogs that may be impeding the suction.
2. Dirty filters: Dirty or clogged filters can restrict airflow and reduce suction. Check the pre-motor filter and post-motor filter. Follow the manufacturer's instructions to clean or replace the filters as necessary.
3. Full dust bin: An overly full dust bin can prevent proper suction. Empty the dust bin and ensure it is properly attached back in place.
4. Brush roll issues: Inspect the brush roll for any tangled hair, strings, or debris. Remove any obstruction and ensure the brush roll spins freely.
5. Hose detachment: Check if the hose is properly connected to the main unit and wand. If it's loose or detached, reconnect it securely.
6. Motor or belt problems: If none of the above steps solve the issue, there may be a problem with the motor or belt. In such cases, it's recommended to contact Shark customer support or refer to the user manual for further assistance.
Remember to always refer to the product manual for specific instructions on troubleshooting and maintenance for your Shark Lift-Away NV601UKT model.