SentrySafe T6-331 user manual

To open the battery compartment on a SentrySafe T6-331, please follow these steps:
1. Locate the electronic keypad on the front of the safe.
. Look for a small plastic cover below the keypad. This cover houses the battery compartment.
3. Using your fingers or a small flathead screwdriver, gently pry open the plastic cover. Be careful not to use excessive force to avoid damaging it.
4. Once the cover is open, you will see the battery compartment inside.
5. Remove any existing batteries if necessary by gently pushing them out from their compartments.
6. Insert new batteries, ensuring they are properly aligned with the positive (+) and negative (-) terminals.
7. Close the battery compartment cover, making sure it snaps securely into place.
8. Test the keypad to ensure that the new batteries are functioning properly.
Please note that the specific steps may vary slightly depending on the model and design of your SentrySafe. Always refer to the user manual provided with your safe for accurate instructions.

The code on the SentrySafe T6-331 is a 3 to 8 digit combination code.

To clear a Sentry safe error, you can follow these steps:
1. Remove the batteries from the safe and leave them out for about 10 minutes. This will allow the safe to reset itself.
2. After 10 minutes, reinsert the batteries into the safe.
3. Enter the factory code or the user code you have set previously. The keypad may flash red if the code is entered incorrectly.
4. If the error persists, try using the override key that came with the safe. Insert the key into the keyhole and turn it clockwise until the door opens. This method overrides any electronic errors and allows manual access to the safe.
5. Once the safe is open, examine the error message or indicator to determine the specific issue. Consult the user manual or contact SentrySafe customer support for further assistance.
Remember to keep your user code and override key in a secure place to prevent unauthorized access.