Roberts ECOLOGIC-4 user manual

To reset your Roberts radio, you can follow these general steps:
1. Unplug the radio from the power source.
. Wait for a few seconds or a couple of minutes.
3. Plug the radio back into the power source.
This simple action should effectively reset your Roberts radio. However, if you're facing specific issues or require more detailed instructions, consult the user manual for your specific model of Roberts radio. It will provide you with specific guidance on how to reset the radio, as different models might have different reset procedures. You can usually find the user manual on the manufacturer's website.

Follow these steps to turn off the alarm on a Roberts Ecologic-4 alarm clock radio:
1. Press the Wake button.
. The indicators for Wake 1, Wake 2, or both will appear in the display.
3. Press the Off button to cancel both alarms.
4. The relevant Wake indicators will disappear from the display and the alarms will be turned off.
However, bear in mind that the instructions may vary slightly between different models. If the given instructions do not work, refer to your user manual or contact the Roberts customer support.

There could be various reasons why your Roberts radio is not working. Here are a few common issues and possible solutions:
1. Power: Make sure the radio is connected to a power source and turned on. Check the power cord and ensure it is properly plugged into an electrical outlet.

. Batteries: If your Roberts radio is battery-operated, check if the batteries are properly inserted and not depleted. Try replacing them with fresh batteries to see if it resolves the issue.

3. Antenna: If you are experiencing poor reception or no sound at all, check the antenna's position and adjust it for better signal reception. You can also try extending or repositioning the antenna to get a better signal.
4. Volume and mute: Make sure the volume is turned up and not on mute. Adjust the volume level using the control buttons or dials on your radio.
5. Tuning: If you are experiencing difficulty tuning into stations, ensure you are using the correct frequency or station settings. Try retuning the radio by using the auto-tune or manual tune feature to find available stations.
6. Faulty speaker or audio jack: If there is no sound coming from the radio, test it with a different set of speakers or headphones. If the audio is working on external speakers or headphones, the problem could be with the radio's built-in speaker or audio jack.
If you have tried these troubleshooting steps and your Roberts radio is still not working, you may need to contact the manufacturer's customer support for further assistance or consider getting it repaired.

To reset the Roberts Ecologic-4, you can follow these steps:
1. Unplug the power cord from the electrical outlet.
. Remove any batteries from the radio if applicable.
3. Press and hold the Power/Mode button for at least 15-20 seconds.
4. While holding the Power/Mode button, plug the power cord back into the electrical outlet.
5. Continue holding the Power/Mode button for another 15-20 seconds.
6. Release the Power/Mode button and wait for a few seconds.
7. The radio should now be reset to its factory settings.
Note: Resetting the device will erase any saved presets or settings, so you may need to set them up again after the reset.