QNAP TS-453D-4G user manual

No, the QNAP TS-453D-4G NAS does not have built-in WiFi. It does have dual 2.5GbE RJ45 LAN ports for Ethernet connection. However, it can support wireless connectivity if you use a compatible USB WiFi adapter.

The QNAP TS-453D-4G supports a maximum RAM of 8GB.

To connect your QNAP TS-453D-4G storage, please follow these steps:
1. Connect one end of the Ethernet cable to the LAN port on the back of the QNAP storage device.
. Connect the other end of the Ethernet cable to your router or network switch.
3. Plug in the power adapter to the power port on the back of the QNAP storage device.
4. Connect the power adapter to a power outlet.
5. Press the power button on the front panel of the QNAP storage device to turn it on.
6. Wait for the device to boot up, which may take a few minutes.
Once the device is powered on and connected to your network, you can access it using different methods:
Via QNAP Finder:
1. Download and install QNAP Finder from the QNAP website (https://www.qnap.com/en/download?model=).
. Open QNAP Finder and it should automatically detect your QNAP storage device on your network.
3. Click on the device name in the QNAP Finder to access the device's web configuration interface.
Via IP address:
1. Check the IP address assigned to the QNAP storage device using your router's web interface or a network scanning tool.
. Open a web browser on your computer.
3. Enter the IP address of the QNAP storage device into the address bar.
4. Press Enter to access the web configuration interface.
Note: The default login credentials for QNAP devices are usually admin/admin or admin/no password. Please refer to the user manual or documentation for your specific model if you encounter any issues.