PURE ONE-CLASSIC-SERIES-2 user manual

To reset your Roberts radio, you can follow these general steps:
1. Unplug the radio from the power source.
. Wait for a few seconds or a couple of minutes.
3. Plug the radio back into the power source.
This simple action should effectively reset your Roberts radio. However, if you're facing specific issues or require more detailed instructions, consult the user manual for your specific model of Roberts radio. It will provide you with specific guidance on how to reset the radio, as different models might have different reset procedures. You can usually find the user manual on the manufacturer's website.

To reset your Pure One Classic Series 2 DAB radio, you can follow these steps:
1. Turn off the radio and unplug it from the power source.
. Wait for about 10 seconds.
3. Press and hold down the Info button while simultaneously plugging the power cord back into the radio.
4. Keep holding the Info button until you see the word "Reset" or "Factory Reset" appear on the display. This usually takes around 5 seconds.
5. Release the Info button.
6. The radio will now reset and restart. You may need to go through the initial setup process again, such as choosing your language and scanning for DAB stations.
Please note that performing a factory reset will erase any presets, saved settings, and stored information on your radio, so make sure to write down any important settings or presets before resetting.

To reset a Sony DAB radio, you can follow these steps:
1. Locate the power button on the radio and turn it off.
. Unplug the radio from the power source.
3. Wait for about 30 seconds to 1 minute.
4. Plug the radio back into the power source.
5. Turn on the power button to switch on the radio again.
This basic power cycle/reset can often resolve minor issues with the radio. If the problem persists, you may need to consult the user manual or contact Sony customer support for further assistance.

To clean a Pure One Classic Series 2 radio, you can follow these steps:
1. Start by making sure that the radio is turned off and unplugged from the power source. This will prevent any accidents and ensure your safety.
2. Use a soft, lint-free cloth or a microfiber cloth to gently wipe the exterior of the radio. Avoid using any harsh chemicals or abrasive materials that could scratch or damage the surface. A damp cloth is usually sufficient for light cleaning.
3. If there are any stubborn stains or dirt on the radio, you can dampen the cloth slightly with a mild detergent or soap solution. Wring out the cloth well to avoid excessive moisture and then gently wipe the affected areas. Be sure to remove any excess soap residue using a clean, damp cloth afterwards.
4. Take extra care with any buttons or knobs on the radio. Use a soft, dry toothbrush or a cotton swab dipped in rubbing alcohol to clean these smaller and more delicate areas. They tend to accumulate dust, dirt, or debris, so ensure that you clean them thoroughly.
5. To clean the speaker grilles, you can use a vacuum cleaner with a brush attachment or a can of compressed air. Gently run the brush attachment or spray the compressed air across the grilles to remove any dust or particles that may have accumulated.
6. Lastly, allow the radio to fully dry before plugging it back into the power source or turning it on. This is important to prevent any damage due to moisture.
Following these steps should help you clean your Pure One Classic Series 2 radio effectively. Remember to always refer to the manufacturer's instructions for any specific cleaning and maintenance recommendations for your particular radio model.