Pioneer MVH-390BT user manual

To reset the Pioneer MVH-390BT car stereo, you can try the following steps:
1. Turn off the stereo by pressing and holding the Source (or SRC) button until the unit powers off.
. Once the stereo is turned off, press and hold the Source button again until the unit powers back on. Keep holding the button.
3. After a few seconds, the unit should display the Initial Setup screen or a Reset prompt.
4. Release the Source button and follow the on-screen instructions to confirm the reset.
Please note that the exact steps may vary slightly depending on the firmware version of your specific model. If these steps don't work, you can refer to the user manual for more detailed instructions or contact Pioneer customer support for further assistance.

To connect your Bluetooth device to your Pioneer MVH-390BT car stereo, follow these steps:
1. Turn on the Bluetooth function on your mobile device (phone, tablet, etc.).
. Press the "SRC" (source) button on the Pioneer MVH-390BT unit to switch to the Bluetooth source.
3. The stereo will start searching for available Bluetooth devices. On your mobile device, go to the Bluetooth settings and select "MVH-390BT" from the list of available devices.
4. If prompted, enter the PIN code "0000" or "1234" to pair the devices. Note that some devices may connect automatically without a PIN code.
5. Once the pairing is successful, the Pioneer unit will display "Connected" or your device name on the screen.
6. You can now play audio from your mobile device through the car stereo using Bluetooth. You can also control music playback and access other Bluetooth features using the stereo's controls.
Remember to enable Bluetooth and reconnect your device to the Pioneer MVH-390BT whenever you get into your car to automatically establish a connection.