Philips WAKE-UP-LIGHT-HF3510 user manual

The Philips Wake-Up Light HF3510 does not have a physical reset button. However, you can reset the device by unplugging it from the power source for about 10 seconds and then plugging it back in.

To adjust the brightness on your Philips wake-up light, follow these steps:
1. Plug in your Philips wake-up light and ensure it is turned on.
. Press the "Settings" button on the device. This button is usually located on the front panel or the top of the alarm clock.
3. Use the "+" and "-" buttons to increase or decrease the brightness levels. The buttons are usually located near the Settings button.
4. Continue pressing the "+" or "-" buttons until you reach your desired brightness level.
5. Some Philips wake-up lights also have preset brightness levels, so you can cycle through them by pressing the "Settings" button repeatedly until you find a suitable level.
6. Once you have achieved your desired brightness, wait for a few seconds, and the wake-up light will save the new setting automatically.
Note: The exact method to adjust brightness may vary slightly depending on the model of your Philips wake-up light. Always refer to the user manual specific to your device for detailed instructions.

To change the time on your Philips wake-up clock (model HF3510), please follow these steps:
1. Press the "Clock Set" button on the top of the clock.
. The display will show the currently set wake-up time.
3. Press and hold the "Clock Set" button until the hours digits start blinking.
4. Use the "+" and "-" buttons to adjust the hours. Press the "Clock Set" button once to confirm the hours setting.
5. The minutes digits will start blinking. Use the "+" and "-" buttons to adjust the minutes.
6. Press the "Clock Set" button once more to confirm the new time setting.
Your wake-up clock's time should now be successfully changed to the desired time.