NOCO GENIUS-10 user manual

The charging time for a NOCO Genius 10 battery charger largely depends on the battery's capacity and the charge level. However, as a general guideline, it typically takes approximately 3 to 5 hours to charge a typical 12-volt automotive battery from 0% to 100%. Keep in mind that larger batteries with higher capacities may require more time to fully charge. It is important to consult the manufacturer's instructions for the specific model you are using, as charge times can vary.

The specific light indicators on a Noco Boost model may vary depending on the specific model. However, in general, Noco Boost devices usually have an array of LED lights that indicate the charging status and battery level. Here are the common light indications:
1. Power light: This light indicates that the Noco Boost is turned on and ready to charge or provide power.
2. Charging light: When connected to a power source, this light indicates that the Noco Boost is currently charging itself.
3. Boost light: This light indicates that the Noco Boost is in the boost mode and ready to jump-start a vehicle.
4. Battery level lights: These lights give an indication of the remaining battery capacity. Typically, there are multiple lights, each representing a specific battery level range (e.g., low, medium, high).
5. Error light: In some models, there might be an error light that illuminates when there is an issue with the Noco Boost, such as reverse polarity or overheating.
It is recommended to refer to the user manual or specific product documentation for detailed information regarding the light indicators for a specific Noco Boost model.

The duration of NOCO Genius 10 repair mode can vary depending on the specific battery condition, but typically it takes around 4 to 12 hours of continuous charging. However, please note that the actual charging time can be influenced by factors such as battery size, capacity, age, and the extent of damage or discharge.