Nikon COOLPIX-P610 user manual

1. First, make sure the Wi-Fi option on your camera is set to Enable. If not, please go to the Setup Menu and select the Wi-Fi option and then click on Enable.
2. Press the Wi-Fi button on the camera. This will open the Wi-Fi menu.
3. In the Wi-Fi menu, you will be presented with four options. Choose the "Network connection" option.
4. Connect to the network screen will appear. Select "Network settings" to set up a new connection.
5. You will be presented with a list of available Wi-Fi networks. Select your network name from the list. If your network is not shown, you can select Add Open Network or Add Hidden Network to manually enter the information.
6. If your network is protected by a password, a screen will be displayed for you to enter the password. Use the camera's multi selector to enter your password, then select Done and press OK.
7. At the Authentication screen, select WPA/WPA2 PSK if you are not sure about your security protocol. Most Wi-Fi networks use this protocol.
8. Select Auto for the IP address settings. Unless your network configuration requires a static IP, this is the most straightforward choice.
9. Now, a verification screen will be displayed, showing the network to which the camera will connect, as well as the network settings. Review the information, and if all data is correct, press OK. If you need to make changes, select the Back option.
10. Information appears on the screen confirming that the camera has connected to the network.
Remember to ensure that the camera and the router are within range, and the Wi-Fi signal is good enough to establish a connection. For better performance and to reduce interference, keep the distance between the camera and the router as minimum as possible.

There can be several reasons why your Nikon Coolpix P610 may not be working. It could be due to a technical malfunction, power issues, software glitches, or user error. Here are a few troubleshooting steps you can try:
1. Check the battery: Ensure that the battery is charged and properly inserted into the camera. If the battery is dead, try charging it or replacing it with a new one.
2. Power cycle: Turn off the camera, remove the battery and memory card, wait for a few minutes, and then reinsert them. Turn on the camera again and see if it starts working.
3. Check the lens: Sometimes, a stuck or misaligned lens can prevent the camera from functioning correctly. Make sure the lens is not obstructed, and try gently rotating or pushing it to see if it frees up.
4. Reset settings: If there are any software or settings-related issues, you can perform a factory reset on the camera. Refer to the camera's user manual for instructions on how to reset it to default settings.
5. Update firmware: Visit Nikon's official website and check if there are any firmware updates for your Coolpix P610. If available, follow the instructions to update the camera's firmware.
6. Contact Nikon support: If none of the above steps work, it might indicate a more significant problem that requires professional assistance. Reach out to Nikon's customer support or take your camera to an authorized service center for diagnosis and repair.
Keep in mind that these are general suggestions, and the exact solution might vary based on the specific issue your camera is experiencing.

The Nikon Coolpix P610 was released in February 2015.

It depends on the specific Coolpix model you are asking about. Nikon has produced several different models in the Coolpix line over the years, and some older models may have been discontinued. However, Nikon continues to release new Coolpix models, so it is still an active product line overall.