Miele WDA-110-WCS user manual

There could be several reasons why the drain spin function on your Miele WDA-110-WCS washing machine is not working:
1. Clogged Drain Pump: Check if the drain pump or its filter is clogged with debris or lint. This can obstruct the flow of water and prevent the machine from draining properly.
2. Faulty Drain Pump: The drain pump itself might be faulty or malfunctioning. In this case, you may need to replace it with a new one.
3. Blockage in the Drain Hose: Examine the drain hose to see if it's bent, kinked, or obstructed. Ensure that it is properly connected and not damaged or blocked by any objects.
4. Drain Hose Height: Make sure the height of the drain hose is at the correct level. If it is too high, it may not allow the water to drain effectively. Refer to the user manual for the proper installation guidelines.
5. Clogged or Faulty Pressure Switch: The pressure switch is responsible for detecting water levels in the machine. If it is clogged or not functioning properly, it might not signal the machine to initiate the drain spin cycle.
6. Electronic Control Board Issue: A malfunctioning electronic control board can also cause problems with the drain spin cycle. In this case, it may need to be repaired or replaced by a professional technician.
If you are unsure about how to troubleshoot or fix the issue, it's recommended to contact Miele customer service or a qualified technician for assistance.

To master reset your Miele washing machine, you can follow these steps:
1. Turn off the washing machine by pressing the power button.
. Unplug the machine from the electrical outlet.
3. Wait for at least one minute to allow all the capacitors to discharge.
4. Plug the machine back into the electrical outlet.
5. Press and hold the "Start/Stop" button and the "Pre-ironing" button simultaneously.
6. While holding both buttons, turn on the machine by pressing the power button.
7. Keep holding both buttons until "System Programme" appears on the display.
8. Release the buttons and the machine will enter the Service Mode.
9. Use the temperature selection dial to navigate through different modes.
10. Find the "Reset" option, usually indicated by an "R" symbol, and select it.
11. Confirm the reset when prompted by the display.
12. Wait for the machine to complete the reset process, and then it will restart.
Note: The specific steps may vary slightly depending on the model of your Miele washing machine. It's always recommended to consult the user manual provided by Miele for your specific model for accurate instructions. Also, keep in mind that performing a master reset will erase any customized settings and revert the machine back to its factory default settings.

To clean the rubber seal on your Miele washing machine, follow these steps:
1. Start by wearing gloves to protect your hands.
2. Open the door of the washing machine and locate the rubber seal, also known as the door gasket.
3. Look for any visible dirt, grime, or mold on the rubber seal. If there is loose debris, remove it by hand.
4. Use a damp cloth or sponge to wipe the entire rubber seal, removing any surface dirt or stains. You can also use warm soapy water, mild detergent, or a mixture of water and vinegar for added cleaning power.
5. For stubborn stains or mold, you may need to use an old toothbrush or a small brush with soft bristles to scrub the affected areas. Be gentle to avoid damaging the rubber seal.
6. After scrubbing, use a clean cloth or sponge to rinse the rubber seal with plain water. Make sure to remove any soap or detergent residue.
7. Once the rubber seal is clean, dry it thoroughly with a clean cloth or towel. Pay attention to any crevices or hard-to-reach areas where moisture can accumulate.
8. After cleaning, leave the washing machine door open for some time to allow air circulation and prevent the growth of mold or mildew.
Following these steps regularly will help maintain the cleanliness of your Miele washing machine's rubber seal.