Linx 1020 user manual

To charge your Linx 10 tablet, follow these steps:
1. Plug the USB cable into the charging port on the tablet. The charging port is usually located on the bottom or the side of the tablet.
. Connect the other end of the USB cable to a power source, such as a computer USB port or a wall adapter. Make sure the power source is turned on.
3. Once the cable is connected, the tablet should start charging automatically. You should see a battery icon or an indicator on the screen showing that it is charging.
4. Leave the tablet connected to the power source until it reaches a sufficient charge. It may take a couple of hours to fully charge the tablet, depending on the battery level.
5. You can check the battery status by swiping down from the top of the screen to open the notification panel. Look for the battery percentage or icon to see the current charge level.
Remember to use the original USB cable and charger that came with the Linx 10 tablet for optimal charging performance.

To factory reset your Linx 1020 tablet, follow these steps:
1. Start by turning off your Linx tablet completely.
. Press and hold the Volume Up button, then press and hold the Power button until the Linx logo appears. Release the Power button but continue holding the Volume Up button.
3. You should enter the UEFI/BIOS settings menu. Use the Volume Up and Volume Down buttons to navigate through the menu options, and the Power button to select an option.
4. Locate and select the "Recovery" option. This should take you to a screen with different recovery options.
5. Select the "Reset this PC" option, and then choose whether to keep your personal files or remove everything. Keep in mind that choosing to remove everything will erase all data on your tablet.
6. Follow the on-screen prompts to confirm the reset. This process may take a while as the tablet reinstalls the original factory settings.
7. Once the reset is complete, your Linx tablet will restart and be restored to its original factory settings.
Note: It's essential to have your Linx tablet charged or connected to a power source throughout the factory reset process to avoid any interruptions.

To reset your Linx 12x64, you can follow these steps:
1. Make sure the device is turned off completely.
2. Press and hold the volume up button, then press and hold the power button at the same time.
3. Keep holding both buttons until the Linx logo appears on the screen. Once you see the logo, you can release the buttons.
4. You will then be taken to the UEFI/BIOS settings menu. Use the volume up and volume down buttons to navigate through the options.
5. Look for the "Restore Factory Defaults" or "Reset to Default" option. Select it using the power button.
6. Confirm the reset by selecting "Yes" or "OK" when prompted.
7. Wait for the reset process to complete. This may take a few minutes.
8. Once the reset is done, the device will reboot and start up as if it was brand new.
Note: Resetting your device will erase all your personal data, so make sure to backup any important files before proceeding.