Line 6 HX-STOMP user manual

The Line 6 HX Stomp has over 300 effects and models available, including distortions, delays, reverbs, modulation effects, and more.

The Line 6 HX Stomp can hold up to six blocks, which can be any combination of amps, cabs, effects, or IRs.

The HX Stomp from Line 6 allows you to use up to 6 effect blocks in a single preset. These effect blocks can be a combination of amp models, stompbox effects, and other processing modules. However, it should be noted that certain effects may require more processing power, which may limit the number of effects that can be used simultaneously.

To connect your Line 6 HX Stomp to your computer, you can follow these steps:
1. Firstly, make sure that you have installed the Line 6 HX Edit software on your computer. This will allow you to edit and manage your HX Stomp presets.
2. Connect the USB cable from the HX Stomp's USB port to a USB port on your computer. It's recommended to use a USB 2.0 cable for this connection.
3. Turn on your HX Stomp and wait for it to fully boot up.
4. Launch the Line 6 HX Edit software on your computer.
5. In the HX Edit software, you should see your HX Stomp listed in the device menu. Select your HX Stomp from the list to establish the connection.
6. Once the connection is established, you can start editing and managing your HX Stomp presets using the HX Edit software on your computer.
Note: Make sure that you have the latest drivers and firmware installed for your HX Stomp. You can download these from the Line 6 website.