LiftMaster KPW250 user manual

The default code for LiftMaster KPW250 is typically "123456". However, it is highly recommended to change this default code to a unique and secure one upon installation to ensure maximum security.

To program your US automatic wireless keypad, follow these steps:
1. Locate the program/operate switch on the keypad and set it to the "Program" position.
. Enter your desired four-digit PIN number using the keypad. Ensure it is a number that is easy for you to remember but difficult for others to guess.
3. Press the "Learn" button on your LiftMaster KPW250 wireless keypad. The LED indicator on the keypad will begin flashing.
4. Within 30 seconds, enter your four-digit PIN again and press the "Enter" button on the keypad. The LED indicator should stop flashing, indicating that the PIN has been successfully programmed.
5. Test the keypad by entering your PIN followed by the "Enter" button. The gate or garage door should open or close accordingly.
Note: The exact steps may vary slightly depending on the specific model of your US automatic wireless keypad. It is always recommended to refer to the instruction manual provided by the manufacturer for precise programming instructions.

To reset your Liftmaster KPW250 gate opener keypad, follow these steps:
1. Locate the "Learn" button on your gate opener. It is usually found on the motor housing or near the wiring terminals.
2. Press and hold the "Learn" button until the LED indicator turns off or blinks to indicate that the current programming has been erased.
3. Release the "Learn" button.
4. Immediately enter a new four-digit PIN followed by the "Enter" button. The LED indicator should blink or turn on to confirm that the keypad has been successfully programmed.
5. Test the new PIN by entering it on the keypad and pressing the "Enter" button. The gate should now open or close accordingly.
If you are still experiencing issues or need further assistance, consult your Liftmaster manual or contact Liftmaster's customer support for more specific instructions.