LiftMaster 893MAX user manual

1. For most Liftmaster garage door opener models, you will start by locating the "Learn" button. This can typically be found on the back or side of the motor unit, where the light lens is. This could be either red, green, purple, or yellow depending on the model.
2. Once you have located the button, press and hold it until the LED light next to it goes out. This could take around 6 seconds. This action will clear the opener's memory and all remote controls will be deleted.
3. To reprogram your remote, press and releasing the "Learn" button again. The LED light will light up again.
4. Within 30 seconds, press and hold the button on your remote that you want to program. When the garage opener's lights blink, or you hear a clicking sound, it indicates that the remote has been successfully programmed.
Remember, once you clear the memory, all remote controls and keyless entries will need to be reprogrammed. Also make sure to keep the remote control away from children and avoid any unintended operation while programming. Consult the user manual or professional help if in doubt.

The Learn button on the LiftMaster 893MAX is typically located on the motor unit of your garage door opener. It is usually found near the antenna wire. The specific location may vary depending on the model and type of your opener, so it's best to refer to the instruction manual or contact LiftMaster customer support for precise information.