LG TONE-FREE-HBS-FN6 user manual

There could be several reasons why the red light is blinking on your LG Tone Free earbuds. Here are a few possible explanations:
1. Low battery: The red blinking light on your LG Tone Free could indicate that the battery is running low and needs to be charged. Connect the earbuds to their charging case and ensure that the case itself is charged.
2. Charging in progress: If you are currently charging your LG Tone Free earbuds, the red blinking light is a normal indication that the earbuds are being charged. It should stop blinking once the charging is complete.
3. Pairing mode: The red light may blink during the initial setup or when the earbuds are in pairing mode. This allows the earbuds to connect to a Bluetooth device. Refer to the user manual or manufacturer's instructions for more details on pairing your earbuds.
4. Software/firmware update: Sometimes, an LG Tone Free earbud may blink a red light when it is receiving a software or firmware update. This could be an automatic update initiated by the earbuds themselves. Make sure the earbuds are connected to your phone, tablet, or computer, and ensure that any available updates are being installed properly.
If the red blinking light persists or you experience any other issues with your LG Tone Free earbuds, it is recommended to consult the user manual or contact LG customer support for further assistance.

To turn up the volume on your LG Tone Free HBS-FN6 earbuds, follow these steps:
1. Ensure that the earbuds are properly connected to your device via Bluetooth.
2. On your device, locate the volume controls. These are usually located on the side of your phone or in the settings menu.
3. Increase the volume using the volume controls on your device. You can either press the physical volume buttons or adjust the slider on the screen.
Note: The LG Tone Free HBS-FN6 earbuds do not have physical volume buttons, so you will need to adjust the volume directly from your device.