La Crosse Technology RADIO-CONTROLLED-ANALOG-CLOCK user manual

To reset the time on a La Crosse Technology radio-controlled analog clock, you can follow these steps:
1. Locate the "RESET" button on the back of the clock. It is usually a small button with the word "RESET" printed below it.
2. Use a pointed object, such as a pen or a paperclip, to press and hold the "RESET" button for a few seconds until the clock display starts to flash or the hands start to move rapidly.
3. Once the clock display is flashing or the hands are moving rapidly, release the "RESET" button.
4. Wait for the clock to automatically search for the radio signal. This may take a couple of minutes. The clock will usually rotate the hour and minute hands on its own until it synchronizes with the signal.
5. Once the clock has successfully received the radio signal and synchronized, it will update the time to the correct one. The display will stop flashing, and the hands will start moving normally.
Note: Ensure that the clock is placed in an area where it can receive the radio signal, usually near a window. Additionally, make sure the clock's battery is not low as it may affect the synchronization process.

To reset your La Crosse Technology wall clock, you can follow these steps:
1. Remove the battery from the clock and wait for at least 10 seconds.
. Insert the battery back into the clock.
3. Press and hold the time or set button on the clock for a few seconds until the hour digits start flashing.
4. Use the + or - button to set the correct hour.
5. Press the time or set button again to move to the minute setting. The minute digits should start flashing.
6. Use the + or - button to set the correct minute.
7. Press the time or set button once more to finish setting the time.
Note: If your clock has additional features like a calendar or temperature display, you may need to follow specific instructions provided in the user manual for setting those features.