Krups NESPRESSO-ATELIER-XN8908 user manual

To reset your Nespresso Atelier XN8908 machine, you can follow these steps:
1. Make sure the machine is plugged in and turned on.
. Press and hold the "Lungo" button for around 5 seconds.
3. The machine will enter the descaling mode, and the power button will start blinking quickly.
4. Release the "Lungo" button to reset the machine.
5. The blinking will slow down, indicating that the machine has been reset.
6. You can now turn off the machine and turn it back on to use it normally.
Please note that this process may vary slightly depending on the specific model or firmware version of your Nespresso Atelier machine.

To use the Krups Nespresso Atelier XN8908, follow these steps:
1. Fill the water tank: Remove the water tank located at the back of the machine and fill it with fresh water. Place the tank back into its position.
2. Power on the machine: Switch on the power button located on the right side of the machine. The machine will start preheating.
3. Prepare your coffee capsule: Lift the lever on the top of the machine to open the capsule compartment. Insert a Nespresso coffee capsule of your choice into the compartment and close the lever firmly.
4. Select coffee size and temperature: On the touch screen display, you can choose your desired coffee size (from Espresso to Lungo) and adjust the temperature according to your preference.
5. Start brewing: Once you're satisfied with your coffee settings, press the start button on the touch screen display. The machine will begin brewing your coffee.
6. Enjoy your coffee: The Nespresso Atelier will automatically stop brewing when the selected size is reached. The coffee will be dispensed into your cup.
7. Eject the used capsule: Lift the lever again to open the capsule compartment. The used capsule will drop into the container. Close the lever.
8. Cleaning and maintenance: The machine will prompt you when it requires cleaning or descaling. Follow the instructions on the screen to perform the necessary maintenance tasks.
Note: It's important to refer to the user manual that comes with the Nespresso Atelier for detailed instructions specific to your machine model.

To descale your Krups Nespresso Atelier XN8908 machine, you can follow these steps:
1. Make sure the water tank is filled with clean water and remove any capsules from the machine.
2. Place a container with a minimum capacity of 1.5 liters under the coffee outlet to collect the descaling solution and water.
3. Press the Power button to turn on the machine and wait until it has reached the ready state.
4. Now, press and hold both the espresso button and the large cup button simultaneously for 5 seconds. The alert light will turn on, indicating that the descaling mode has been activated.
5. Empty the drip tray and cup storage area and then remove the water tank. Fill it with 500ml of descaling solution and 500ml of water. Mix the solution by shaking the tank gently.
6. Place the water tank back into the machine, ensuring it is properly seated.
7. Press the large cup button to start the descaling process. The descaling solution will begin to flow through the machine, dispensing into the container.
8. Allow the entire solution to pass through the machine. This will take around 20 minutes.
9. Once the flow stops, the machine will enter the rinsing phase. Empty the container and place it back under the coffee outlet.
10. Press the large cup button to start the rinsing process. This will rinse the machine with fresh water and remove any remaining descaling solution. The rinsing phase takes approximately 3 minutes.
11. After the rinsing phase is complete, the machine will automatically shut off. Empty and clean the drip tray and cup storage area.
12. Rinse the water tank thoroughly and refill it with fresh water.
13. Finally, place the water tank back into the machine and perform two rinsing cycles by pressing the large cup button. Dispose of the water from each rinsing cycle.
Your Nespresso Atelier machine is now descaled and ready to use again.