Kenmore 796-31622-ELITE user manual

The Kenmore Elite dryer sanitize cycle is a special feature designed to eliminate germs and bacteria from clothing. During this cycle, the dryer heats up to a high temperature, typically around 150°F (65°C), and maintains it for a certain period to kill any bacteria present on the clothes. This helps to eliminate odors and ensure a hygienic drying process. It is recommended to follow the manufacturer's guidelines for using the sanitize cycle, as the specific settings and duration may vary depending on the model.

To reset your Kenmore Elite refrigerator, follow the steps below:
1. Unplug the refrigerator from the power outlet or turn off the circuit breaker that powers it.
2. Wait for at least 60 seconds to allow the refrigerator to completely power down.
3. Plug the refrigerator back into the power outlet or turn on the circuit breaker.
4. Locate the control panel on the front of the refrigerator, typically above the water dispenser or inside the refrigerator's door.
5. Depending on the specific model, press and hold either the "Lock" and "Filter Reset" buttons simultaneously or the "Control Lock" and "Freezer Temperature" buttons simultaneously for about 3 to 5 seconds. Consult your refrigerator's manual if you're unsure which buttons to use.
6. Release the buttons once you see the control panel displays turn off and then back on or hear a confirmation beep.
7. The Kenmore Elite refrigerator is now reset, and you can restore your preferred settings.
Note: If your refrigerator has a control lock feature, ensure the control lock is not activated before attempting the reset. The buttons used for resetting may vary depending on the refrigerator's model, so always refer to your specific model's manual for accurate instructions.

The CL code on a Kenmore Elite dryer usually indicates a control lockout feature. This feature is designed to prevent accidental changes to the settings during operation. To unlock the control panel, you can press and hold the cycle selection button or the start button for a few seconds until the CL code disappears.