Jura IMPRESSA-C5 user manual

To change the filter on a Jura Impressa C5, follow these steps:
1. Ensure that the coffee machine is turned off and unplugged from the power source.
2. Open the top cover of the machine by lifting it.
3. Locate the water tank on the right-hand side of the machine and remove it by lifting it upwards.
4. Empty out any remaining water from the tank and remove the filter cartridge if it's still present.
5. Rinse the new filter cartridge under running water for 30 seconds.
6. Insert the new filter cartridge into the water tank with the round side facing upwards.
7. Place the water tank back into the machine and ensure it is fully seated.
8. Close the top cover of the machine.
9. Plug in the machine and turn it on.
10. The display will show a reminder to "Change Filter." Press the "Maintenance" button on the control panel.
11. Navigate to the "Change Filter" option using the arrow buttons, then press the "Enter" button.
12. The display will ask if you want to reset the filter. Press the "Enter" button to confirm.
13. The machine will now reset the filter indicator and is ready to make coffee with the new filter.
Note: It is recommended to change the filter approximately every 2 months or after brewing around 50 liters of water. The specific time may vary depending on the water hardness in your area.

To change the language on your Jura Impressa S9, follow these steps:
1. Turn on the machine by pressing the power button.
. Open the service door and locate the rotary dial on the left side of the machine.
3. Turn the rotary dial until you see the "Language" option displayed on the screen.
4. Press the "Enter" button to enter the language settings menu.
5. Use the rotary dial to scroll through the available languages until you find your desired language.
6. Press the "Enter" button to confirm the language selection.
7. Close the service door.
Your Jura Impressa S9 will now be set to the selected language.

The Jura Impressa F90 was released in 2001.