JLab GO-AIR user manual

The meaning of colors on JLab earbuds may vary depending on the specific model and features. However, generally, the colors on JLab earbuds indicate different functions or states. Here are some common examples:
1. Blue: On some models, a blue color may indicate that the earbuds are powered on, connected, or in pairing mode.
2. Red: Red often represents low battery or charging status. When the earbuds are low on battery or actively charging, they may display a red light.
3. Green: A green color may indicate a fully charged battery or a successful connection to a device.
4. White: Some JLab earbuds have white LED indicators to convey various functions like power status, pairing mode, or successful Bluetooth connection.
It's important to refer to the specific user manual or instructions provided with your JLab earbuds to get accurate information about the colors and their meanings for your particular model.

To know if your JLab earbuds are in pairing mode, follow these steps:
1. Turn on your JLab earbuds by pressing and holding the power button until they power up. Most JLab earbuds have a flashing LED light when turned on.
. Make sure your earbuds are not already connected to any other device. Disconnect them from any previously connected devices if needed.
3. Consult the user manual of your specific JLab earbuds to know the exact pairing mode process, as it may slightly vary among different models.
4. Generally, to enter pairing mode, you might need to press and hold the power button or a dedicated pairing button on the earbuds. The LED lights on the earbuds may start flashing alternatively, or you may hear an audio prompt indicating that the earbuds are in pairing mode.
5. Additionally, check the LED lights on the earbuds. If they are blinking rapidly or alternating between colors, it may indicate that the earbuds are in pairing mode.
6. Once the earbuds are in pairing mode, you can proceed with the pairing process on your desired device (e.g., smartphone, tablet, etc.) by searching for available Bluetooth devices and selecting your JLab earbuds from the list.
If you're unsure about the specific steps for your JLab earbuds, refer to the user manual or contact JLab customer support for further assistance.

To control JLab earbuds, you can use the integrated controls on the earbuds themselves. The specific control features may vary depending on the JLab earbud model you are using, but here are some common functions and instructions:
1. Play/Pause: Press the center button once to play or pause audio playback.
2. Volume Control: Most JLab earbuds allow you to adjust the volume. To increase the volume, press the volume up button (usually located on the earbud). To decrease the volume, press the volume down button (usually located on the opposite side).
3. Track Control: JLab earbuds often have the ability to skip tracks forward or backward. Pressing the center button twice quickly usually skips the next track, while pressing the center button three times quickly usually skips to the previous track.
4. Answer/End Calls: When receiving an incoming call, you can use the center button to answer the call. Press the button to answer, and press it again to end the call.
5. Voice Assistant: Some JLab earbuds have a voice assistant feature. Usually, you can activate it by pressing and holding the center button until you hear a prompt indicating that the voice assistant is ready.
It's important to refer to the user manual or JLab's support documentation for your specific earbud model to ensure you're following the correct instructions.