JLab GO-AIR-SPORT user manual

To turn on your JLab Air Sport without a case, please follow these steps:
1. Locate the power button on your JLab Air Sport earbuds. It is typically located on the side or bottom of the earbud.
2. Press and hold the power button for a few seconds until you see a blinking LED light or hear a power-on tone. This indicates that the earbuds are turning on.
3. Once the earbuds are powered on, they will enter pairing mode automatically. Look for the earbuds' name ("JLab Air Sport" or similar) in the Bluetooth settings of your device.
4. Connect your device to the JLab Air Sport earbuds by selecting their name from the list of available devices. Follow any additional prompts that may appear on your device's screen.
Once successfully connected, you can start using your JLab Air Sport earbuds for listening to music or making calls. Keep in mind that without a case, you will need to manually power off the earbuds after use to preserve battery life. To power off, press and hold the power button again until the LED light turns off or you hear a power-off tone.

The controls for JLab earbuds may vary depending on the specific model. However, here are the general controls that are commonly found on JLab earbuds:
1. Power/Play/Pause:
- Press and hold the main button or power button for a few seconds to turn on or off the earbuds.
- Press the main button or power button once to start or pause audio playback.
2. Volume Control:
- To increase the volume, press the volume up button, usually located on the right earbud.
- To decrease the volume, press the volume down button, usually located on the right earbud.
3. Track Control:
- Press the main button once to skip to the next track.
- Press the main button twice to skip to the previous track.
4. Answer/End Calls:
- To answer an incoming call, press the main button once.
- To end an ongoing call, press the main button once.
5. Voice Assistant:
- Some JLab earbuds have a dedicated voice assistant button, allowing you to activate voice commands with your paired device's voice assistant (e.g., Siri or Google Assistant).
Keep in mind that these controls can vary, so it's always helpful to refer to the user manual or product documentation specific to your JLab earbuds for accurate and detailed control instructions.

The meaning of colors on JLab earbuds may vary depending on the specific model and features. However, generally, the colors on JLab earbuds indicate different functions or states. Here are some common examples:
1. Blue: On some models, a blue color may indicate that the earbuds are powered on, connected, or in pairing mode.
2. Red: Red often represents low battery or charging status. When the earbuds are low on battery or actively charging, they may display a red light.
3. Green: A green color may indicate a fully charged battery or a successful connection to a device.
4. White: Some JLab earbuds have white LED indicators to convey various functions like power status, pairing mode, or successful Bluetooth connection.
It's important to refer to the specific user manual or instructions provided with your JLab earbuds to get accurate information about the colors and their meanings for your particular model.

To turn on your JLab Go Air Sport earbuds, follow these steps:
1. Take your earbuds out of the charging case.
. Ensure that the earbuds are charged (if not, place them back in the case to charge).
3. Press and hold the button on both earbuds simultaneously for about 3-5 seconds until you see a flashing LED light on both earbuds.
4. Once the LED lights start flashing, it means your earbuds are powered on and ready to pair.
After turning on your earbuds, you can then proceed with pairing them to your device via Bluetooth.