JBL WAVE-300TWS user manual

To use the JBL Wave-300TWS earbuds, follow these steps:
1. Make sure the earbuds are charged by placing them inside the charging case and connecting the case to a power source via a USB cable. Allow them to charge until the LED indicator on the case turns solid white.
2. Take the earbuds out of the charging case. They should turn on automatically and enter the pairing mode. The LED lights on the earbuds will start flashing blue and white.
3. On your smartphone or device, enable Bluetooth and search for available devices. Select "JBL Wave-300TWS" from the list of available devices to pair the earbuds.
4. Once paired, you can use the touch-sensitive controls on the earbuds to control playback, volume, and calls. Here are some basic controls:
- Single tap the right earbud to play/pause music or answer/end calls.
- Single tap the left earbud to enable voice assistant or decline calls.
- Double tap the right earbud to skip to the next track.
- Double tap the left earbud to go back to the previous track.
- Swipe up or down on either earbud to adjust the volume.
- Long press the right or left earbud for 2 seconds to activate the ambient sound mode, allowing you to hear the surrounding environment.
5. When you're done using the earbuds, place them back into the charging case to automatically turn them off and start charging again.
Remember to consult the user manual for more detailed instructions specific to the JBL Wave-300TWS earbuds, as different models may have slight variations in controls and features.

The JBL Wave 300TWS has LED lights on both earbuds that indicate various states and functions. Here's a breakdown of what the lights mean:
1. Power On/Off: When you power on the earbuds, the LED will flash white. When you power them off, the LED will remain off.
2. Battery Level: You can check the battery level of the earbuds by pressing the button on the charging case. The LED light on the charging case will indicate the battery level as follows:
- Green: High battery level (70-100%)
- Yellow: Medium battery level (20-70%)
- Red: Low battery level (0-20%)
- Blinking red light: Critical battery level (less than 5%)
3. Pairing Mode: When you put the earbuds in pairing mode, the LED light on each earbud will flash blue and white alternately.
4. Charging Status: While the earbuds are charging, the LED light on the charging case will be solid white. Once fully charged, the LED light will turn off.
5. Bluetooth Connectivity: When the earbuds are connected to a Bluetooth device, the LED light on the right earbud will be solid white. If the LED blinks white, it indicates that the earbuds are trying to reconnect to a previously paired device.
It's worth noting that the exact behavior of the LED lights may vary depending on the specific model and firmware version of the JBL wave-300TWS earbuds. Always refer to the user manual for precise instructions on interpreting the LED indicators.

To put the JBL Wave-300TWS earbuds in pairing mode, you can follow these steps:
1. Make sure the earbuds are charged and turned off.
. Take both earbuds out of the charging case.
3. Press and hold the button on both earbuds simultaneously for about 6 seconds until they enter pairing mode.
4. The LED lights on the earbuds will start flashing rapidly, indicating they are in pairing mode.
Once the earbuds are in pairing mode, you can go to the Bluetooth settings on your device (phone, tablet, etc.) and select the JBL Wave-300TWS from the list of available devices to connect them.