JBL ENDURANCE-PEAK-II user manual

To control your JBL Endurance Peak wireless earphones, you can use the following steps:
1. Power On/Off: To turn your earphones on, press and hold the power button located on the right earpiece for about 3 seconds until you see the LED lights flashing. Repeat the same process to turn them off.
2. Pairing: To connect your Endurance Peak with a Bluetooth device, ensure the earphones are in pairing mode (LED lights flashing rapidly). Go to the Bluetooth settings on your device, search for available devices, and select "JBL Endurance Peak" to pair.
3. Volume control: Use the volume buttons on the right earpiece to increase or decrease the volume. Press the top button to increase and the bottom button to decrease the volume.
4. Play/Pause and Skipping Tracks: To play or pause music, press the center button on the right earpiece once. To skip to the next track, press and hold the center button for about 2 seconds. For the previous track, press and hold the center button on the left earpiece for about 2 seconds.
5. Call Management: To answer an incoming call, press the center button on the right earpiece once. To end a call, press the same button again. If you wish to reject a call, press and hold the center button for about 2 seconds.
6. Voice Assistant: Press and hold the center button on either earpiece for about 2 seconds to activate voice assistant functions, such as Siri or Google Assistant, depending on your device.
Note: The exact control mechanisms may vary slightly based on the specific JBL Endurance Peak model you own. It is recommended to refer to the user manual that came with your earphones for more detailed instructions.

To use the JBL Endurance Peak II, follow these steps:
1. Turn on the earbuds by removing them from the charging case. They should automatically power on and pair with each other.
2. On your mobile device, enable Bluetooth and search for available devices.
3. From the Bluetooth menu, select "JBL Endurance Peak II" to pair with the earbuds. Once connected, you will hear a confirmation sound in the earbuds.
4. The earbuds come with touch controls on the outside surface. You can tap once on either earbud to play/pause music or answer/end calls. A double-tap on the right earbud will skip to the next track, and a double-tap on the left earbud will go to the previous track.
5. Adjust the volume by swiping up or down on either earbud's surface.
6. To activate the voice assistant on your device, tap and hold the right earbud's surface.
7. The earbuds have built-in microphones, so you can use them for hands-free calling.
8. When you're finished using the earbuds, place them back in the charging case. They will automatically turn off and start charging.
Remember to consult the user manual provided by JBL for any specific instructions or additional features of the JBL Endurance Peak II earbuds.