iRobot ROOMBA-630 user manual

Yes, the reset button on the Roomba 630 is located on the underside of the robot. It is a small hole near the main power switch. You can use a paperclip or a similar object to press and hold the reset button for a few seconds to reset the Roomba.

Using your Roomba 630 robotic vacuum cleaner can be pretty straightforward. Here are the steps:
1. Charge your Roomba: In order to get started with your Roomba 630, you need to charge it for at least 3 hours.
2. Once it's fully charged, remove any excess clutter from the floors of the area you want cleaned. This makes it easier for the Roomba to clean without getting stuck.
3. Turn on your Roomba: Press the "CLEAN" button once to turn on your Roomba 630. The light around the button should turn on.
4. Start the Cleaning Cycle: Press the "CLEAN" button once more to start the cleaning process. The Roomba will move out of its Home Base and begin cleaning.
5. Let it clean: Roomba 630 has iAdapt Navigation which uses a full suite of sensors to navigate and adapt to your changing home.
6. If the battery gets low during Cleaning, Roomba will return to its Home Base to recharge.
7. Once the cleaning cycle is complete or if the battery is running low, the Roomba 630 will automatically return to its Home Base to dock and recharge.
In case you want to Pause the cleaning cycle: You can press "CLEAN" while Roomba is cleaning and then press it again when you want it to start cleaning.
Note: To clean specific spots, you can carry Roomba to the desired room and then press "Spot" on the Roomba. It will clean a small area around its starting position.
Moreover, Roomba 630 can be scheduled to clean up to seven times a week. Use the following commands: "Clock," "Schedule," and "Day," "Hour," and "Minute."
Remember, routine maintenance, including cleaning the brushes and emptying the bin, will help to ensure an optimal performance.

The Roomba 630 model was first released in 2012, so it is approximately 9 years old as of 2021.

There could be several reasons why your Roomba 630 is not charging. Here are a few possible causes:
1. Check the power cord: Ensure that the power cord is securely plugged into both the charging dock and the power outlet. Make sure there are no visible damages to the cord.
2. Clean the charging contacts: Over time, the charging contacts on the Roomba and the dock may get dirty or covered in dust. Use a clean, dry cloth to wipe the charging contacts on both the Roomba and the dock. Also, clean the metal contacts on the battery.
3. Reset the Roomba: Resetting the Roomba can resolve some charging issues. To reset, press and hold the CLEAN button for about 10 seconds until you hear a tone. Then release the button and let the Roomba restart.
4. Replace the battery: If your Roomba has been used for a long time, the battery may have reached the end of its lifespan. Consider replacing the battery with a new one to see if it solves the charging problem.
5. Check for software updates: Sometimes, Roomba charging issues can be related to software glitches. Ensure that your Roomba is updated with the latest firmware. You can check for updates through the iRobot HOME app or on iRobot's website.
6. Contact customer support: If none of the above solutions work, it's best to contact iRobot customer support for further assistance. They can provide specific troubleshooting steps or recommend repairs if needed.