Humax HD-FOX user manual

To manually tune your Humax HD-FOX box, follow these steps:
1. Ensure your TV is switched on and set to the correct input source for the Humax box.
. Press the "Menu" button on the Humax remote control.
3. Use the arrow keys on the remote to navigate to the "Settings" option and then press "OK."
4. Navigate to "Installation" or "Setup" and press "OK."
5. Select "Manual Search" or "Manual Tune" and press "OK."
6. Enter the frequency of the channel you want to tune in. You can find the correct frequency by referring to the channel's documentation or conducting an online search.
7. Once you've entered the frequency, select the appropriate settings for modulation, symbol rate, and other parameters. You may need to refer to the channel's documentation or conduct online research to find these values.
8. After selecting the parameters, press the "OK" button to initiate the manual tuning process.
9. The Humax box will scan for channels with the specified frequency and settings. This process may take a few minutes.
10. Once the scan is complete, the Humax box will display a list of any channels it has found. You can navigate through the list using the arrow keys on the remote.
11. Scroll through the list and select any channels you want to add to your channel lineup. Press "OK" to add a channel.
12. Repeat steps 6 to 11 for any additional channels you want to tune manually.
13. Once you've finished manually tuning all the desired channels, press the "Exit" or "Menu" button on the remote to exit the menu.
Please note that the exact steps may vary slightly depending on the specific model of your Humax HD-FOX box. Refer to the user manual accompanying your device for precise instructions.

Yes, there is a reset button on the Humax HD-FOX. It is located on the front panel of the receiver, typically near the power button. To reset the device, you can press and hold the reset button for about 10 seconds until the receiver restarts. Keep in mind that performing a reset will erase all personalized settings and stored data on the device, so make sure to back up any important information before proceeding.

Yes, as of my knowledge in October 2021, Humax is still in business. They are a leading manufacturer of digital set-top boxes, digital video recorders (DVRs), and other consumer electronics. However, it's always a good idea to check for the most recent information as business statuses can change over time.

There could be several reasons why your Humax HD-FOX box has stopped working. Some possible causes include:
1. Power issues: Check if the power cable is securely connected to both the box and the power outlet. Also, ensure that the power outlet is functioning correctly by trying a different device. If there is a power outage or surge, it might have affected the box.
2. Software/firmware issues: Sometimes, software or firmware updates can cause compatibility problems or errors. Try performing a software/firmware update if available. If you can't access the menus on the box, try a factory reset. Instructions for this can usually be found in the device's manual or on the manufacturer's website.
3. Signal problems: If you're unable to receive any channels or experience poor signal quality, it could be due to a weak or interrupted signal. Verify your antenna/cable connection is secure and unobstructed. You may also want to try a different cable or antenna to rule out any damage or issues with the current one.
4. Hardware failure: Over time, any electronic device can experience hardware failures. If none of the above steps resolve the issue, it's possible that a component inside the box has malfunctioned or failed. In such cases, it might be necessary to contact the manufacturer or a professional repair service for assistance.
It's worth noting that these are general troubleshooting steps and the specific issue might vary. If you're unsure or unable to resolve the problem, reaching out to Humax customer support or consulting with a technician would be advisable.