Huawei 5G-CPE-PRO-2 user manual

Huawei 5G router generally includes some light indicators to show the status of different functionalities. Here is the general interpretation of these lights:
1. **Power**: It indicates whether the power is turned on or off. When the light is solid green, it means the router is turned on whereas an off light means the router is not powered.
2. **Signal Strength**: This indicator gives information about the strength of the signal. The more LED lights are on, the stronger the signal. If the indicator is off, it means the router is not connected to a network.
3. **LAN/WAN**: When the light is solid green, it means that the router is connected to an Ethernet network. If it is blinking, it means data is being transmitted. If the light is off, no Ethernet cable is connected.
4. **WPS**: WPS stands for Wi-Fi Protected Setup. The light turns on or blinks when WPS is in process. It remains off when not in use.
5. **WiFi**: If this light is solid green, the WiFi is enabled. If it’s blinking, that means data is being transmitted over WiFi. If the light is off, the WiFi is disabled.
6. **5G/4G**: This light indicator would tell if the router is connected to a 5G or 4G network. If the light is off, there is no Internet connection.
Remember that light indications may vary with different models of routers. Always refer to the user manual to get the accurate interpretation of these lights.
Note: Huawei's 5G Router may have a Signal indicator color change depending on signal situation.
-Solid green: normal signal.
-Solid red: no signal or very weak signal.
-Solid orange: weak signal (service may be affected).

To reset your Huawei 5G CPE router, you can follow these steps:
1. Locate the reset button on the back of the router. It is usually a small hole labeled "RESET."
2. Use a pin or paperclip to press and hold the reset button for about 10 seconds. Make sure the router is powered on while doing this.
3. Release the reset button after 10 seconds. The router will reboot and restore to its factory settings.
Note that resetting the router will erase all your custom settings, including the Wi-Fi name and password. After the reset, you will need to set up the router again and personalize your settings.

To log into your Huawei 5G CPE Pro 2 router, you can follow these steps:
1. Connect your device (PC, laptop, smartphone, etc.) to your Huawei 5G CPE Pro 2 router using either an Ethernet cable or by connecting to the router's Wi-Fi network.
2. Open a web browser (such as Chrome, Firefox, or Safari) on your device.
3. In the address bar, type the default IP address of the router: 192.168.8.1 and press Enter. Alternatively, you can also try entering "http://huawei.router" or "http://192.168.3.1".
4. You will be directed to the router's login page. Here, enter the default username and password. The default username is "admin", and the default password is also "admin". If these credentials don't work, you may need to check the label on the back of your router for the correct login details.
5. After entering the correct username and password, click on the "Sign in" or "Login" button.
6. If the credentials are correct, you should now be logged into your Huawei 5G CPE Pro 2 router's web interface.
Note: It is important to change the default password after logging in to ensure the security of your router.

The default admin password for Huawei 5G CPE Pro 2 is usually printed on a sticker or label placed on the device itself. However, if the label is not present or you cannot find it, the default admin password is typically "admin".