HP LASERJET-PRO-MFP-M148FDW user manual

To connect your HP LaserJet Pro MFP m148fdw to the WiFi, follow these steps:
1. Turn on the printer and make sure it's in a ready state.
2. On the printer’s control panel, navigate to the “Network” or “Wireless” menu.
3. Choose "Wireless Settings" and then "Wireless Setup Wizard".
4. The printer will search for wireless networks.
5. Once the search is complete, a list of available networks will be displayed.
6. Choose your network from the list and enter the password if prompted. Most domestic wireless routers use WPA or WPA2 security, which will require a password.
7. Follow the on-screen instructions to complete your setup.
If you can't find your network, make sure your printer is within the network's range and the correct network name has been entered.
As soon as your printer establishes a successful connection to the wireless network, the screen will display a confirmation message. You can now print wirelessly from your computer.
Remember to install the printer's software on your computer if you haven't done so already.
Please note: In some models, the wireless options are found directly in the menu of the touchscreen control panel.

To manually feed paper into your HP LaserJet Pro MFP M148fdw, follow the steps below:
1. Open the paper input tray located at the front of the printer.
. Ensure that the adjustable paper guides are set according to the width of the paper you're using.
3. Take a stack of paper and tap it gently on a flat surface to align the edges.
4. Insert the stack of paper into the input tray, with the print side facing down and the short edge forward.
5. Adjust the paper guides to touch the sides of the stack, but not too tight to avoid bending the paper.
6. Push the stack of paper until it stops.
7. Close the paper input tray securely.
Note: Make sure to align the paper guides correctly and not overload the tray beyond its maximum limit to prevent paper jams.
You can now use the manual feed feature on your HP LaserJet Pro MFP M148fdw. Through the printer's control panel or print settings on your computer, specify manual feed as the paper source for printing.

To perform a factory reset on your HP LaserJet Pro MFP M148fdw, you can follow these steps:
1. Turn off the printer by pressing the power button.
. Disconnect the power cord from the printer.
3. Leave the printer disconnected for about 30 seconds.
4. Reconnect the power cord to the printer.
5. Press and hold the Stop button (located next to the power button) while you turn on the printer.
6. Continue holding the Stop button until the control panel displays "Select Language."
7. Release the Stop button.
8. Use the arrow keys on the control panel to navigate to "Restore Factory Settings" and press the OK button.
9. Select "Restore" and press the OK button to confirm the reset process.
10. Wait for the printer to complete the reset process and return to the "Select Language" prompt.
After the reset, the printer will be restored to its default settings. Keep in mind that all previously configured settings, network configurations, and stored data will be lost.

I'm sorry, but I can't provide the password for a specific device like the LaserJet Pro MFP M148fdw. The password is typically set by the user or the administrator. You may need to refer to the device's manual or contact the manufacturer for assistance with resetting or retrieving the password.