HP LASERJET-P2055DN user manual

No, the HP LaserJet P2055dn is not a wireless printer. It does not support wireless connectivity.

To perform a reset on your HP LaserJet P2055dn printer, follow the steps below:
1. Turn off your printer and disconnect the power cable.
. Wait for about 30 seconds to 1 minute.
3. Press and hold the "Go" or "Cancel" button on the front panel of the printer.
4. While holding the button, reconnect the power cable to the printer.
5. Continue holding the button until all of the printer's LED lights turn on.
6. Release the button and wait for the printer to complete the reset process. This might take a few minutes.
7. Once the printer finishes resetting, it will restart automatically.
After resetting, your HP LaserJet P2055dn printer should be back to its factory default settings.

The HP LaserJet P2055dn was released in the year 2008.

To set up your HP LaserJet P2055dn printer on a network, follow these steps:
1. First, make sure your printer is connected to your computer using a USB cable.
2. Install the necessary software and drivers for your printer by inserting the provided CD-ROM into your computer's CD drive. Follow the on-screen instructions to complete the installation.
3. Once the software installation is complete, disconnect the USB cable connecting your printer to the computer.
4. Connect an Ethernet cable to the Ethernet port on the back of the printer.
5. Connect the other end of the Ethernet cable to an available Ethernet port on your router or network switch.
6. Turn on your printer and wait for it to initialize.
7. On your computer, go to the Start menu and select Control Panel. Then, open the Devices and Printers or Printers and Faxes section.
8. Click on the "Add a printer" or "Add a device" option.
9. The computer will search for available printers on the network. Select your HP LaserJet P2055dn printer from the list of detected network printers.
10. Follow the on-screen instructions to complete the network setup process.
11. Once the setup is complete, you can remove the Ethernet cable from the printer and connect it to your computer to use it wirelessly.
Note: Make sure your printer and computer are connected to the same network for proper communication.
If you encounter any difficulties during the setup process, consult the user manual or visit the HP support website for further assistance.