HP LASERJET-P2035 user manual

I'm sorry, I don't have access to current product information. However, as of my last knowledge, the HP LaserJet P2035 printer was not discontinued and was still available for purchase. To get the most accurate and up-to-date information, I recommend checking the official HP website or contacting their customer support.

To perform a complete reset of your HP LaserJet P2035 printer, follow these steps:
1. Turn off the printer.
. Disconnect the printer's power cable from the electrical outlet.
3. Disconnect the printer's USB or Ethernet cable from the computer or network.
4. Wait for about 30 seconds to allow any remaining power to discharge.
5. Reconnect the printer's power cable to the electrical outlet.
6. Press and hold the "Go" button on the front panel of the printer.
7. While holding the "Go" button, turn on the printer.
8. Continue holding the "Go" button until the Attention, Ready, and Go lights on the printer's control panel all turn on.
9. Release the "Go" button. The Attention and Ready lights will continue to blink while the Go light will remain off.
10. Wait for about 10 seconds and then press the "Go" button again. The Attention and Ready lights will turn on, and the Go light will turn off.
11. Wait for the printer to complete its initialization and network configuration. This might take a few minutes.
12. Once the printer has finished initializing, it should be reset to its factory defaults.
Note: Before resetting your printer, make sure to backup any custom settings or configurations as they will be lost during the reset process.

To print the configuration page on your HP LaserJet P2035 printer, follow these steps:
1. Ensure that your printer is turned on and connected to your computer.
. Open the printer driver setup window by going to the Control Panel on your computer.
3. Select "Devices and Printers" or "Printers and Scanners" (depending on your operating system) from the Control Panel.
4. Locate your HP LaserJet P2035 printer from the list of available printers and right-click on it.
5. Click on "Printer Properties" or "Printing Preferences" from the context menu.
6. In the printer properties window, go to the "Device Settings" or "Advanced" tab.
7. Look for an option called "Print Configuration" or "Print Configuration Page".
8. Check the box next to the "Print Configuration" option if it is available.
9. Click on the "Apply" or "OK" button to save the changes.
10. Now, initiate the printing of the configuration page by selecting "Print" or "OK" (or similar) in the printer properties window or by sending a print command from your computer.
The configuration page will be printed by your HP LaserJet P2035 printer, providing you with information about the printer's settings, network configuration, firmware version, and other useful details.