HP DESKJET-1110 user manual

To reset your HP DeskJet 1110 printer, you can follow the steps below:
1. Make sure the printer is turned on.
. Disconnect the power cord from the printer.
3. Wait for about 1-2 minutes.
4. Reconnect the power cord to the printer.
5. Press the Power button to turn on the printer.
After completing these steps, your HP DeskJet 1110 printer should be reset and ready to use.

To put ink in your HP DeskJet 1110, follow these steps:
1. Open the ink cartridge access door. The carriage moves to the center of the printer. Wait until the carriage is idle and silent before proceeding.
2. Remove the new ink cartridge from its packaging. Make sure to hold it by the plastic body and avoid touching the copper-colored contacts or ink nozzles.
3. Open the ink cartridge slot by pulling it forward. Place the ink cartridge into the slot at a slight upward angle, and then gently push it in until it snaps into place.
4. Repeat the steps for any additional ink cartridges you need to replace.
5. Close the ink cartridge access door. The printer will automatically print an alignment page. Make sure to load plain white paper into the input tray if prompted.
And that's it! Your HP DeskJet 1110 is ready to print with the new ink cartridges.

To clean the print head of your HP DeskJet 1110, you can follow these steps:
1. Turn on the printer and ensure there is paper loaded in the input tray.
2. Open the top cover of the printer to access the ink cartridges.
3. Wait until the carriage with the ink cartridges moves to the center of the printer and becomes idle.
4. Unplug the power cord from the printer to ensure safety while cleaning.
5. Lift the latch handle on the carriage, holding the ink cartridges, and gently remove the cartridges from their slots.
6. Locate the printhead and identify the metal electrical contacts on it.
7. Dampen a lint-free cloth or paper towel with distilled water. Ensure it is not dripping and is only slightly wet.
8. Gently wipe the electrical contacts of the printhead with the damp cloth or paper towel. Be careful not to touch the nozzles or other parts of the printhead.
9. Allow the printhead to dry for a few minutes.
10. Reinsert the ink cartridges into their respective slots and close the latch handle until it clicks into place.
11. Close the top cover of the printer.
12. Plug the power cord back into the printer and turn it on.
Your HP DeskJet 1110 printer should now have a clean print head.