Honeywell HR92 user manual

To bind a Honeywell HR92, you need to follow these steps:
1. Start by placing the HR92 device in binding mode. To do this, press and hold the button located on the bottom right corner of the HR92 until a flashing red LED appears.
2. Next, you'll need to put the Honeywell heating controller (e.g., Honeywell Evohome controller or Honeywell Sundial RF² time controller) into binding mode. Refer to the specific instructions for your Honeywell heating controller to find the binding mode.
3. Once the heating controller is in binding mode, it will start searching for the HR92. At this point, the HR92's red LED should start flashing rapidly to indicate it is in discovery mode.
4. Make sure the HR92 and heating controller are within range of each other (usually within 30 meters or so) and wait for them to complete the binding process. This can take a few seconds to a minute.
5. Once the binding is successful, the red LED on both the HR92 and heating controller should stop flashing, indicating that they are now bound together.
6. Finally, you may need to assign the HR92 to a specific zone on your heating controller, depending on the system you are using. Refer to the heating controller's instructions for how to do this, as it may vary between different Honeywell systems.
Following these steps should allow you to successfully bind a Honeywell HR92 to your heating controller. Remember to consult the relevant manuals for your specific devices if you encounter any issues or variations in the process.

The Honeywell HR92 radiator controller operates on two AA batteries. According to Honeywell, the battery life can last up to two years depending on usage.

To reset your HR92UK Honeywell radiator controller to its default settings, follow these steps:
1. Press and hold the middle button on the front of the HR92UK until the unit shows "OFF" on the display.
. Release the button and then immediately press and hold it again for approximately 5 seconds until the screen displays "P" for programming mode.
3. While in programming mode, press the button again to cycle through the available settings until you reach "F" for factory reset.
4. Once "F" is displayed, press and hold the button for around 5 seconds until the HR92UK resets to its default settings.
After the reset is complete, you'll need to reprogram and pair the HR92UK unit with your Honeywell heating system if necessary.

To reset your Honeywell HR92 radiator controller, follow the steps below:
1. Start by removing the HR92 from the radiator valve. You can do this by pulling off the HR92 from its baseplate.
2. Leave the HR92 off the baseplate for a few seconds.
3. Re-attach the HR92 to the baseplate, ensuring that it locks securely in place.
4. On the HR92 thermostat, press and hold the "Menu" button for about 6 seconds until the display changes.
5. Use the up or down arrow buttons to navigate to the "Factory reset" option on the screen.
6. Press the "Menu" button again to confirm the factory reset.
7. The HR92 will reset and revert to its default settings.
After the reset, you may need to reconfigure the HR92 radiator controller and pair it with your central heating system. Refer to the user manual or consult the manufacturer's website for detailed instructions on how to set up and configure the HR92 after the reset.