Hayward SUPER-PUMP user manual

The model number on a Hayward Super Pump can typically be found on the pump's housing or motor. It is usually imprinted on a white or silver sticker or plate, and it may also include other information such as the voltage and horsepower rating. Make sure to check both the pump housing and the motor for the model number.

There can be several reasons why your Hayward pump is not working. Here are some common issues that you can check:
1. Check the power supply: Ensure the pump is properly connected to a power source and there is power available. Check the circuit breaker to see if it has tripped, and if so, reset it.
2. Check the impeller: The impeller may be clogged or jammed, preventing it from spinning. Inspect the impeller for any debris or obstructions, and remove if necessary.
3. Check the motor: The motor might have burned out or developed a fault. Look for any visible signs of damage such as melted wires or a burnt smell. If present, the motor may need to be repaired or replaced.
4. Check the lid and o-ring: Ensure that the lid and o-ring of the pump are properly seated and tightened. If they are loose or damaged, it may cause a loss of prime and prevent the pump from functioning.
5. Check the suction and discharge lines: Examine the suction and discharge lines for any blockages or restrictions that may be preventing proper water flow. Clear any debris if necessary.
6. Check the pump basket: The pump basket might be full of debris, causing it to clog. Remove the basket, clean it, and ensure it is securely in place.
If you have checked these common issues and the pump still does not work, it may be necessary to contact a professional pool technician for further inspection and repair.