Graco DUET-CONNECT-LX user manual

Disassembling a Graco Duet Connect LX swing and bouncer can be quite simple if the steps are followed correctly. Below are the steps:
1. Remove the mobile by rotating it anti-clockwise.
2. Unclip the bouncer seat from the swing mode: There are two clips attaching the seat to the frame of the swing. Squeeze these clips, which will release the seat.
3. Detach the cords found in the back of the swing base by removing the electronic module. This will disconnect the swing motion.
4. Once the seat and cords are removed, you can start disassembling the frame.
5. Start by pushing up on the buttons on the sides of the main vertical bar to detach the upper frame bars.
6. Release the gripping locks between the frame parts. Remove the upper part of the frame.
7. Then disassemble the base legs by pressing the buttons on the pins where they are attached. Pull them apart, and then twist and pull the legs off.
8. Lastly, the seat cover can be removed and thrown in the laundry if needed: there are levers on the back and bottom of the seat where the fabric is attached.
Please be sure to keep all parts in a safe place for reassembly. You would also want to consult your user manual for any specific instructions related to your model since parts may differ based on the model.

To turn a Graco Duet Connect LX swing into a bouncer, you can follow the steps below:
1. Start by removing the swing seat from the swing frame or base. Ensure the seat is detached properly, following the manufacturer's instructions.
2. Once the seat is removed, you can set it on a flat surface.
3. Locate the detachable vibration unit on the swing seat. This unit is usually on the side or bottom of the seat.
4. Disconnect the vibration unit from the seat by unclipping or unplugging it. Refer to the user manual or instructions to find the specific method for your model.
5. After removing the vibration unit, you can adjust the seat into a more upright position for use as a bouncer. You can typically do this by adjusting the recline angle or seat position according to your desired level of comfort and support for your little one.
6. Attach any additional accessory or toys, if available and desired.
7. Ensure that the seat is securely locked in place and stable before placing your baby in it.
Note: It's important to follow the manufacturer's instructions and guidelines throughout the process to ensure the safety of your child. If you're unsure or need further assistance, it's recommended to refer to the user manual or contact Graco customer support for detailed instructions.