Gorenje W6443 user manual

To reset your Gorenje W6443 washing machine, follow these steps:
1. Turn off the washing machine by pressing the power button or unplugging it from the power source.
. Wait for about 30 seconds before proceeding.
3. Press and hold the Start/Pause button and the Restricted Spins button simultaneously.
4. While holding these buttons down, turn the washing machine back on by pressing the power button or plugging it back into the power source.
5. Continue holding the buttons until the display shows "FP" or "F-". Once you see this, you can release the buttons.
6. The washing machine has now been reset, and you can proceed with your desired settings and program selection.
Note: The steps provided here are general instructions for most Gorenje washing machines. However, it's always recommended to refer to your specific model's user manual for detailed instructions on how to reset it, as the process may slightly vary depending on the model.

The F4 error code on a Gorenje washing machine typically signifies an issue with the water fill. This could result from problems like the tap being turned off, a kink in the hose, a blocked filter, or a faulty water inlet valve. It's recommended to check these areas or consult a professional for repair as necessary.

To drain a Gorenje W6443 washing machine, follow these steps:
1. Turn off the power to the machine and unplug it from the electrical outlet for safety.
. Locate the drain hose at the back of the machine. It is usually grey or white in color and connected to the plumbing system.
3. Place a shallow container or towel on the floor near the machine to catch any excess water that may spill during the draining process.
4. Pull out the drain hose from its resting position and lower it to a level below the water level inside the machine. This will allow gravity to pull the water out.
5. Secure the hose in place, ensuring that it doesn't retract back into the machine or fall out of the container.
6. Open the pump filter access panel on the lower front of the machine. This is usually a small rectangular cover.
7. Remove the pump filter cap by turning it counterclockwise. Be cautious as some water may still be inside, so be prepared to catch it with a towel or container.
8. Let the water completely drain out into the container, ensuring that it doesn't overflow.
9. Once all the water has drained, clean the pump filter by removing any debris or lint trapped inside it. Rinse it under running water if necessary.
10. Reinstall the pump filter cap by turning it clockwise until it is securely in place.
11. Raise the drain hose back to its original position and ensure it is properly connected to the plumbing system.
12. Close the pump filter access panel, making sure it clicks into place.
13. Plug the washing machine back into the electrical outlet and turn on the power.
14. The machine should now be drained and ready for use.
Note: It's always a good idea to consult the instruction manual specific to your Gorenje W6443 washing machine for detailed instructions and any additional steps specific to your model.

The error code E4 on a Gorenje washing machine indicates a water intake issue. This could mean that the water faucet is closed, water supply is turned off, or there is a problem with the water inlet valve. It is recommended to check the water supply and make sure it is properly connected and turned on. If the issue persists, it may require professional servicing or contacting Gorenje customer support for further assistance.