Eureka AIRSPEED-AS3033A user manual

There could be several reasons why your Eureka Flash stick vacuum brush is not spinning. Here are a few possible causes and troubleshooting steps you can try:
1. Clogged brushroll: The brushroll may be clogged with debris like hair, fibers, or other obstructions. Turn off and unplug the vacuum, then remove the brushroll by following the manufacturer's instructions. Clean the brushroll thoroughly and remove any tangled debris. Reattach the brushroll and try again.
2. Faulty belt: Check if the belt that drives the brushroll is broken or worn out. Over time, the belt can stretch or snap, preventing the brush from spinning. Consult the user manual to locate the belt and inspect its condition. If it appears damaged, consider replacing it with a genuine Eureka replacement belt.
3. Motor issue: The motor that powers the brushroll may have encountered a fault or malfunction. If you've checked the brushroll and belt and they appear to be in good condition, it's possible that the motor may need professional repair or replacement. Contact Eureka customer support or a qualified technician for assistance.
4. Power connection: Ensure that the vacuum is properly plugged in and that there is an adequate power supply. Check the power cord for any damage or loose connections. If the issue persists, try using the vacuum in a different outlet to rule out a power supply problem.
If after trying these troubleshooting steps the brush still does not spin, it is recommended to reach out to Eureka customer support for further assistance or consider taking it to a certified technician for repair.