Electrolux EWC-1350 user manual

If your Electrolux EWC-1350 washer isn't draining automatically, you might be able to manually drain it by following these steps:
1. Cancel the current cycle: To start the process, you will need to cancel the ongoing wash cycle. You can do this by pressing the "cancel" button on the washer's control panel.
2. Unplug the washing machine: To ensure safety, unplug the washing machine from the electrical outlet.
3. Access the drain pump: The drain pump is often located at the bottom of the machine, behind a small door or cover. Open this and have a small bucket or towel ready, as some water may come out.
4. Clean the drain pump: Electrolux washing machines often have a coin trap in the pump designed to catch small items like coins or hairpins that could damage the pump. Remove any visible debris and clean the pump filter if it's accessible.
5. Look for a drain hose: If the washer is still full of water, you might need to manually drain the water out. Most washers have a small drain hose next to the pump filter. Pull this out slightly, unplug the cap, and let the water drain into a bucket.
6. Reassemble and test: Once you've cleaned both the pump and the filter and manually drained the water if necessary, you can reassemble the machine. Plug it back in, run a rinse cycle, and ensure it drains properly.
If even after following these steps the washer still doesn't drain, you might have a fault with the pump itself, the control board, or the drain hose could be clogged. At this point it would be advisable to call a professional to diagnose and fix the problem.

To use the Electrolux clean washer cycle on the EWC-1350 model, follow these steps:
1. Ensure that the washing machine is empty and that there is no laundry inside.
. Make sure the water supply to the washing machine is turned on.
3. Close the washer door properly.
4. Turn the washer on by pressing the power button.
5. Press the "Program" button on the control panel to cycle through the available wash programs until you reach the "Clean Washer" setting. The specific button labeling may vary, but it usually looks like a running water droplet.
6. Once you have selected the "Clean Washer" program, press the "Start" button to begin the cycle.
7. The machine will automatically fill with water and start agitating to clean the tub and other internal components.
8. Allow the cycle to complete. The duration may vary depending on the specific model, but it typically takes around 2-3 hours.
9. Once the clean washer cycle finishes, you can open the door and remove any remaining water by wiping the interior with a clean cloth or sponge.
10. It is advisable to leave the washer door open for a while after the cleaning cycle to allow the interior to dry out and prevent any potential odors.
Remember to consult the user manual for your specific model for detailed instructions, as they may vary slightly.

To get your Electrolux EWC-1350 washer to spin only, you can follow these steps:
1. Turn on the washer by plugging it into a power outlet and ensuring that the water supply is connected.
2. Load your laundry into the washing machine and close the door securely.
3. Press the "Power" button to turn on the washer.
4. Select the desired spin cycle by rotating the cycle selector knob to the appropriate setting. Look for a cycle specifically labeled "Spin" or "Spin Only." The cycle settings may vary slightly depending on the model, but there should be options for spin-only cycles.
5. Adjust the spin speed using the spin speed selector knob if necessary. This knob might have options like "High," "Medium," or "Low." Select the desired spin speed based on your preferences or the type of fabric you are washing.
6. Press the "Start" button or the appropriate button on your washer to begin the spin cycle.
7. The washer will start spinning to remove excess water from the clothes without agitating them. It will automatically stop once the spin cycle is complete.
Always refer to your washer's user manual for model-specific instructions, as the functions and control panel layout may differ slightly.