Dyson BALL-ANIMAL user manual

There could be several reasons why your Dyson Ball Animal vacuum stopped working. Here are a few common issues:
1. Power issue: Ensure that the vacuum is properly plugged into a functioning power outlet. Check if the power cord is damaged or if the fuse has blown. Try using the vacuum in another outlet to eliminate this possibility.
2. Overheating: If the vacuum has been used for a long period, it may have overheated. In such cases, the vacuum will automatically shut off to protect the motor. Allow the vacuum to cool down for some time and then try using it again.
3. Blockage: Check if there is any blockage in the vacuum, such as in the hose, wand, or brushbar. Remove any debris that may be obstructing the airflow and affecting its performance.
4. Filter issues: Dirty or clogged filters can also cause the vacuum to stop working properly. Check and clean both the pre-motor and post-motor filters according to the manufacturer's instructions.
5. Brushbar malfunction: The brushbar on the vacuum cleaner may be tangled with hair, threads, or debris, which can prevent it from spinning. Clear any blockage and ensure the brushbar is clean.
If none of these troubleshooting steps solve the issue, it may be necessary to contact the Dyson customer support or take the vacuum to an authorized service center for further assistance or repairs.

The brush bar reset button on a Dyson vacuum cleaner is typically located on the cleaner head. It is often a red or yellow button that can be pressed to reset the brush bar if it gets stuck or tangled. However, the specific location of the reset button may vary depending on the Dyson model. It is best to consult the user manual or contact Dyson customer support for the exact location on your specific model.

To adjust the suction on a Dyson Ball Animal vacuum cleaner, you can follow these steps:
1. Locate the suction control dial: On most Dyson Ball Animal models, the suction control dial can be found on the front of the vacuum cleaner, towards the bottom. It usually has a scale with maximum and minimum indicator marks.
2. Switch off the vacuum cleaner: Before adjusting the suction, make sure the vacuum cleaner is switched off and unplugged from the power source for safety.
3. Rotate the suction control dial: Turn the suction control dial clockwise to increase the suction power or anti-clockwise to decrease it. As you turn the dial, you may feel and hear the changes in the suction intensity.
4. Find the desired suction level: Adjust the dial until you reach the desired suction strength that suits your cleaning needs. You can refer to the indicator marks on the dial to have a rough idea of the suction power level.
5. Test the suction: Once you have set the desired suction level, you can power on the vacuum cleaner and test it on various surfaces to ensure the suction is appropriate for the task at hand.
Remember, the Dyson Ball Animal vacuum cleaner is designed to automatically adjust the suction power based on the surface it is used on. However, the suction control dial allows you to fine-tune the suction intensity for customized cleaning preferences or challenging cleaning situations.