Dyson ASPIRATEURS user manual

To clean the canister of your Dyson vacuum, follow these steps:
1. Turn off and unplug the vacuum: Ensure that the vacuum is not in use and unplugged from the power source before cleaning.
2. Empty the canister: Locate the release catch or button that opens the canister. Press it to release and remove the canister from the vacuum. Hold it over a trash bin and press the release catch again to empty the contents.
3. Rinse with water (canister models only): If you own a Dyson canister model, remove the cyclone unit from the canister by pressing a button or catching. Rinse the cyclone and the clear bin with cold water until the water runs clear.
4. Let it dry: Allow the canister to air dry completely before reassembling it. Placing wet components back into the vacuum may damage it. Ensure all parts are dry and clean before proceeding.
5. Wipe down the outside: Use a damp cloth or sponge to wipe down the outside of the canister to remove any dirt or debris.
6. Reassemble the vacuum: Once the canister is completely dry, reattach the cyclone unit (if applicable) and snap the canister back onto the vacuum. Check that it is securely locked in place before using the vacuum again.
Note: It's always best to refer to the user manual specific to your Dyson model for accurate and detailed instructions on cleaning your vacuum canister.

Starting a Dyson vacuum differs slightly depending on the model. However, most Dyson vacuums have a similar process to start them. Here are some general steps to start a Dyson vacuum:
1. Ensure that the vacuum is plugged into a power outlet and the power cord is securely connected at both ends.
. If your Dyson vacuum has a power switch, turn it to the "On" position. Some models may have a trigger handle that needs to be squeezed for the vacuum to turn on.
3. Most Dyson vacuums have a power button or trigger located on the handle or body of the vacuum. Press or squeeze the button or trigger to activate the vacuum's motor.
4. Once the vacuum is powered on, you can start using it by pushing or pulling the vacuum head over the desired area to be cleaned.
5. Adjust the suction power or settings, if applicable, using the control buttons or switches located on the vacuum's body or handle.
Remember to consult your specific Dyson vacuum model's user manual for detailed instructions, as the steps may vary slightly between models.