Canon POWERSHOT-SX170-IS user manual

To turn on the flash on your Canon PowerShot SX170 IS, follow these steps:
1. Locate the mode dial on the top of the camera and turn it to the desired shooting mode (e.g., P mode, Auto mode, etc.)
. Press the flash button located on the rear of the camera next to the viewfinder.
3. The flash menu will appear on the screen.
4. Use the left or right directional keys on the navigation pad to highlight the desired flash mode (Auto, On, Slow Synchro, or Off).
5. Press the "Func./Set" button at the center of the navigation pad to select the highlighted flash mode.
6. The flash is now turned on, and it will automatically fire whenever it is needed in the selected shooting mode.
Note: In some shooting modes, the camera might have limited control over the flash settings. In such cases, you may need to switch to a different shooting mode to have more control over the flash options.

To turn on your Canon Powershot S80, follow these steps:
1. Locate the power button on your camera. It is usually located on the top or back of the camera, labeled with a power icon.
2. Press and hold the power button for a few seconds until the camera powers on. You should see the Canon logo appear on the screen.
3. Once the camera is powered on, you can start using it by adjusting the settings, focusing, and capturing photos or videos.
Note: If the camera does not turn on, make sure the battery is charged or insert a fully charged battery. If the battery is inserted correctly and the camera still doesn't turn on, you may need to contact customer support for further assistance.

To charge your Canon Powershot SX170 IS, follow these steps:
1. Locate the battery and memory card compartment on the bottom of the camera.
. Open the compartment by sliding the latch and lifting the cover.
3. Insert the rechargeable battery into the compartment with the contacts facing down.
4. Close the compartment securely.
5. Connect the camera to a power source using the provided USB interface cable.
6. If you have a wall socket adapter, connect the USB cable to the adapter and plug it into a standard wall outlet. Alternatively, connect the USB cable directly to a computer or other USB power source.
7. The camera will start charging automatically. The charging indicator light should turn on to indicate that the battery is being charged.
8. Leave the camera connected to the power source until the battery is fully charged. The charging time may vary, but it usually takes a few hours.
9. Once the battery is fully charged, disconnect the camera from the power source by carefully removing the USB cable.
10. Lastly, close the battery and memory card compartment.
It is worth noting that some Canon Powershot SX170 IS models also support charging via a separate battery charger, which is not included with the camera but can be purchased separately. In that case, you would need to remove the battery from the camera, insert it into the charger, and then connect the charger to a power source.