Canon PIXMA-G3202 user manual

To connect your Canon Pixma G3202 printer to Wi-Fi, follow these steps:
1. Ensure that you have the printer’s power cord connected and turn it on. The green light should be steady, and the blue Wi-Fi light should be blinking.
2. Press and hold the Wi-Fi button on the printer until the light stays lit without blinking.
3. Now, press the "Color" button and then the Wi-Fi button again. The Wi-Fi blue light should be blinking quickly, and the green light should be lit.
4. Go to your computer. If you haven't done so already, download and install the setup file for your printer from the Canon website.
5. Open the setup file and follow the on-screen instructions. Select the wireless LAN connection as your connection method.
6. Choose 'Connect via wireless router (recommended)' method.
7. On the subsequent screen, select your Wi-Fi network and enter in your password.
8. The printer should be detected, follow the on-screen instructions to complete the setup.
9. Run a test print to confirm that the connection has been successfully established.
Please note that the steps can vary slightly depending on the computer's operating system. Always refer to Canon's manual for the most accurate information. It is also essential to make sure that your computer and printer are both connected to the same Wi-Fi network.

The C (Color) and B (Black) lights on a Canon Pixma G3202 printer indicate the status of the ink tanks. If they are blinking, it means the ink may be running low or out. Alternatively, it might also indicate that the ink tanks are not installed properly.
Please check the color and black ink levels and ensure the ink tanks are installed correctly. If the issue persists, consider consulting the user manual for further troubleshooting steps or seek assistance from a Canon support center.

To print from your iPad to your Canon Pixma G3202 printer, you have two options:
1. AirPrint:
- Make sure your iPad and Canon Pixma G3202 printer are connected to the same Wi-Fi network.
- Open the app or document you want to print from on your iPad.
- Tap the "Share" or "Print" button (it varies depending on the application).
- Select the printer named "Canon G3200 series" or similar from the list of available printers.
- Configure any necessary print settings like paper size or orientation.
- Tap "Print" to start printing.
2. Canon PRINT Inkjet/SELPHY app:
- Install the Canon PRINT Inkjet/SELPHY app from the App Store on your iPad.
- Open the app and follow the on-screen instructions to set up your printer (make sure it is connected to the same Wi-Fi network).
- Once the setup is complete, open the app and select the type of document you want to print (photo, document, etc.).
- Choose the specific file you want to print, and any necessary print options.
- Tap "Print" to start printing.
Note: Ensure that your Canon Pixma G3202 printer is compatible with AirPrint or the Canon PRINT Inkjet/SELPHY app before attempting to print wirelessly from your iPad.