Brother QL-820NWB user manual

The Brother QL-820NWB is a versatile label printer that can print labels in various sizes. It supports printing labels up to 2.4 inches wide (62mm) and offers a maximum print resolution of 300dpi. However, the specific label sizes that can be printed depend on the label rolls compatible with the printer. The supported label roll sizes for the Brother QL-820NWB include 2.4", 2.3", 2.0", 1.5", and 1.1" wide rolls.

To reset your Brother QL-820NWB label printer, you can follow these steps:
1. Turn off the printer by pressing the power button.
. Disconnect the power cord from the printer.
3. Wait for about 10 seconds and then reconnect the power cord.
4. While pressing and holding the Cut button, press and hold the Power button.
5. Keep holding both these buttons until the printer starts printing a self-test label.
6. Once the self-test label is printed, release both buttons.
7. Your Brother QL-820NWB printer should now be reset to its default settings.
Please note that resetting the printer will clear any customized settings you may have made previously, so make sure to backup any important information before proceeding with the reset.

To connect your Brother label printer QL 820NWB to Wi-Fi, you can follow the steps below:
1. Power on your printer and make sure it is connected to a power source properly.
2. On the printer's control panel, go to the "Settings" menu.
3. Use the up or down arrow buttons to navigate to the "Network" option and press the "OK" or "Enter" button.
4. Select "Wi-Fi" from the list of network options and press the "OK" or "Enter" button.
5. The printer will scan for available Wi-Fi networks. Once the list appears, use the up or down arrow buttons to select your desired network and press the "OK" or "Enter" button.
6. If your Wi-Fi network is secured with a password, you will be prompted to enter the network password using the printer's control panel. Use the alphanumeric keypad on the control panel to enter the password. Make sure to enter it accurately.
7. After entering the correct password, press the "OK" or "Enter" button to confirm.
8. The printer will attempt to connect to the Wi-Fi network. Once successfully connected, it will display a confirmation message on the control panel.
Now, your Brother label printer QL 820NWB should be connected to your Wi-Fi network. You can proceed to configure the printer settings or start printing labels wirelessly.

To pair your Brother QL-820NWB label printer with Bluetooth, follow these steps:
1. Turn on the printer and make sure it is in the Bluetooth mode.
. On your device (computer, smartphone, or tablet), enable Bluetooth.
3. Open the Bluetooth settings on your device and ensure it is discoverable or visible to other Bluetooth devices.
4. On the QL-820NWB printer, press the Menu button to display the menu options.
5. Use the arrow keys to navigate to "Bluetooth Setup" and press OK.
6. Select "Bluetooth Setup Wizard" and press OK.
7. The printer will start searching for available Bluetooth devices.
8. On your device, you should see the Brother QL-820NWB listed as an available device. Select it and confirm the pairing request, if prompted.
9. Once the pairing is successful, the printer's LCD screen will display a confirmation message.
10. You can now send print jobs wirelessly to the QL-820NWB printer using Bluetooth.
Note: The exact steps may vary slightly depending on your device's operating system and Bluetooth settings. Refer to your device's user manual for detailed instructions on Bluetooth pairing.